stuck

So I'm trying to reseal some hydraulic cylinders on a tractor I've saved after sitting for over 10 years. I'm starting with the loader boom cylinders, and I managed to successfully get the gland nut off the first one. The cylinders employ a non-threaded gland nut with a "twist-in" retaining wire...

IH D40 clutch stuck after parked a bit. Last time this happened I spent 5k for a new clutch. I had no clutch after parked in weather a while. I oozed it to a sloped back driveway and put my f150 in front. I tried yanking with clutch blocked. I heated it up by 30 min high idle. Tried again no...

Unfortunately I left my 870 clutch up (not depressed) for a couple of weeks and it is now "frozen" where it will not engage. I warmed the tractor up for half an hour but it still would not release. I banged it into first gear and drove it around a bit and that did not free it up. I was able to...

Has anyone else had an issue getting out of 4WD? It's a year old. 65 hours on it. I did the 50 hr late last summer. Shifts from Hi to low fine. I have tried in high, low and neutral. I've tried easing on the foot pedal forward and reverse. The lever just won't budge.

I live out in a farming community in Chuckey TN, the area that was torn apart recently by hurcane Helene. We used to have about 10 bridges that crossed the Nolachuckey River but now we are left with 3 1/2. The 1/2 is only one lane instead of 2. Of course this has caused some problems because now...

I have a new mx6000 kubota with 55hrs. and can't get it out of 4wd. This is my 4th 4wd tractor so I am not new at it. I have tried all the usual steps, back and forth, lift front end off the ground, turn wheel, ect, and it just won't come out. I am not sure if it is in the linkage as that all...

1739E Massey Ferguson It's really cold here in Indiana. I scraped snow off the driveway yesterday. Everything was fine. Then some one was stuck last night on the hill. So I brought a load of gravel there. I turned it off. When I restarted it the fuel was on really high, almost to 540. When I...

After sitting for about two months, I topped off my T25's fuel tank with about four gallons of diesel. However, the fuel gauge is still reading only half of a tank. When I unscrewed the filler cap, it appeared as though the tank had been under pressure. I saw a video of a TYM 224 that had a mud...

Newbie here. MT357HC under 10 hours I got stuck in some mud and forgot about the option to switch to 4wd so I spun the tires and kept reversing and forwarding trying to get out. Once I remembered 4wd I got out easily. I turned the tractor off to walk and check out the area. Got back in and it...

15 hours on it. Is there a fix for range shifter getting stuck in a gear? This happened when in 4 drive wheel low range. Got it released by taking it out of 4 wheel and rocking forward and back with the shuttle shift. Can this problem be fixed without taking it back to the dealer. I have had it...

I have a 2001 TC33D that I'm having some problems with. The throttle lever is very loose. I feel almost no resistance when I move the lever. When I started the tractor, the engine raced up to about 2200-2300 RPMs. I immediately shut it down. It feels as though the throttle is stuck mostly open...

I have a 2001 dk55 that is stuck in neutral. The shifter feels loose and its not even trying to engage gears. I drained the fluid from the transmission and found a nut and bolt stuck to the magnet. I believe it’s #5 and #6 in this photo. Has anybody had a similar problem or know how hard it’s...

So I had my 5085M hooked up to my big trailer hauling it up a steep hill on my property. I stopped to take a pic, this one: When I got back in the cab, I put in in A1 (lowest gear), and it made an awful racket. I stopped, tried reverse and same deal. The range lever would no longer go into...

I cannot get the hood to open on my XR4140. The button to release is stuck. Any ideas?

One of my electric brakes is stuck on my dump trailer. The wheel won't turn at all, it's real - real stuck! Trailer un-plugged of course. I tried rolling it forward and backward but it's kinda soft ground and it skids the wheel. It has a bit of weight on it, and some traction... it's not just...

Like the title says, the diff local is stuck in the engaged position. I was moving dirt a few weeks back and used the diff lock for more traction and it worked like it’s supposed to. I took my foot off the diff lock pedal and picked up more dirt and noticed both rear wheels were spinning. I...

With winter coming up I'm sure someone is going to go off my road, into the ditch, and get stuck. I used to recover using a Jeep with a winch, but it I no longer own it. My tractor has a hitch, but my rear blade is most likely going to be in the way. So where's the best place to attach a...

Turned off both waterlines under the sink recently for a repair and now the hot side won't reopen. Put enough leverage on the handle to feel the shaft wind up a little and then relax when I let off of it. That shaft can't be that strong and might twist off. Suggestions welcome! (And I am...

Greetings everyone. I'm a first-time tractor owner and purchased a 2022 5520CH with 260 hours last month. After about 10 hours of use this past week, I can no longer change my range. The shifter is stuck in range B and will not come out of gear. I don't see anything obstructing levers...

Any one have complete hand brake linkage diagram from handle to brake,75tn new holland 1998 to 2002

Back tires of 4520P stuck in high range speed. Any of you guys ever experienced this? I can work in high range fine, but when I set to low range the front set is spinning at low range speeds. Is this an easy fix? My dealer maintenance staff says they have a 4 week backlog. I need this fixed pronto.

Hello, I have a Cub Cadet 7265 with hydrostatic transmission. The other day I drove it fine onto our trailer to transport it and turned it off while in gear. When I got it to the barn and went to unload the tractor, shifted it into Neutral and it wouldn’t start. It needs to be in neutral to...

The tractor has been sitting unused for a few years. I have fuel going in and coming out of the return on the injector pump. The fuel shut off solenoid clicks hard like it's working, but no fuel comes out of the injector line ports. Something is obviously stuck, frozen up with the fuel shut...

When trying to use the 3 point today, it stays stuck in the up position. Made sure that the Lift-O-Matic was turned off but the levers are not changing anything. We can see that the levers are rotating on the back of the tractor, but they have no affect. We tried to put weight on the 3 point and...

Friend of mine got stuck on Sunday. He was pulling up close to a steep bank and slid down the embankment into a soft spot. I went over to his place after church and got him out. Here’s the situation when I arrived in my Challenger MT535B. My friend is going down to his Ford compact tractor with...

Friends, the day started off so well. I uncovered the trusty BX2200 from its winter siesta, and it fired right up. I drove to the spot where I store the bucket for the summer, and it came off lickety split. In the process, I engaged the parking brake, but must have applied too much force. Now...

I was digging a hole with my Kubota m59 Backhoe and suddenly it went to the right (when facing rear) as far as it could go, and is holding itself there touching my stabilizer. I cannot reposition it. I came back the next day and it had no problem, started up centered, and it stayed there for...

I was digging a hole with my Kubota m59 Backhoe and suddenly it went to the right (when facing rear) as far as it could go, and is holding itself there touching my stabilizer. I cannot reposition it. I came back the next day and it had no problem, started up centered, and it stayed there for...

Howdy folks. My little ol' 2810 (which has been really good and tough) has a new issue. Both the PTO lever (shift from 540 to 1000) and the 4WD lever right beside it have become nearly impossible to move. My guess was "dust and rust" and I have liberally applied as much WD40 as I had on hand...

Has anyone had an issue with the brake being stuck with the RK21? I’ve narrowed it down to the actual arm that pulls the break at the rear axle, behind the rear tire. The only way I can get it unstuck is to use a piece of rebar and a hammer to drive the lever back , then if I push the brake...

I resurrecting a Bull and the tranny is frozen/rusted together. What would be a good method to free this?

I've seen the threads detailing the fix for the classic stuck gear problem for MF240 tractors. We run a fleet of 8 of them for our harvest season 3 months of the year and for us it is the silent grenade waiting to go off in each machine, we forget about it for weeks or months then at seemingly...

So I just installed a WR Long 3rd function on my DK6010SE HST cab w/5521 loader. Now the damn joystick is frozen in place; will not move up, down, or to either side. I'm hoping the solution is something dumbly simple that I'm overlooking, and not done major malfunction in the loader valve...

Hello, new here I Have a Yanmar F16D tractor that i have had for a few years now that has worked pretty good for me. today I was driving it and went to change from reverse to 2nd gear and it jus stayed in Reverse. I can change the gear lever to any of the r 1 2 3 and it still goes in reverse...

A new TYM owner here. A few months ago I bought a one year old T474 HST with 270 hours. The dealer told me he had sold the tractor as new and all maintenance had been done at his shop and the tractor was in great shape. As an aside but not relevant to my current problem, the tractor needed...

Well, it finally happened. I've only got about 100 hours on my yanmar YT 359 tractor. Just long enough to feel comfortable and try and do something I probably shouldn't have. I was adding a run for my meat pigs to have access to the pond for water. I got a little too aggressive on how far I...

I'm going dane dane dane.....am I gonna have to split this thing? I've got a Massey 1020...luv the little guy, done great service for me. Today I jumped on, it was in First gear slow mode, the clutch was pressed in, started the tractor and there she was moving forward on it's own!! No matter...

I have a Masey Ferguson 2607H with 25hrs on it. I have attached a 3-point attached backhoe and that works fine for digging. The backoe is PTO driven, no other hydraulic connections. The levers for moving the 3-point attachment are not touched, i am sitting on the backhoe and suddenly but the...

hey all, my boyfriend just bought a used sickle bar cutter for his tractor. It came installed with a used and in rough shape knife bar , but ALSO came with a second knife bar. He want to removed the damaged one and put on the other one. The problem is that the knife head bolt is stuck … it just...

I have a 2021 CK3510SE HST. The darn diff lock lever below the left side of my seat feels stuck. It's been that way in the three months that I've owned the tractor. I've stepped on it, pushed on it by hand, tried it in gear, tried it in neutral and tried it after rocking back and forth a bit...

Can't find any other threads on this, but does anyone have any ideas to get the tranny out of Turtle?? I tried rocking, both gently and vigorously, but to no avail. I often run across town with it, and it's a fifteen minute trip in low. (yes, it's a small town.) Any ideas would be welcome...