Question about footings

/ Question about footings #1  

kcir

New member
Joined
Apr 19, 2006
Messages
23
Location
Lake Fork, Texas
Tractor
Kubota 5400
I am wanting to build a 20x40 concrete pad 4" with a metal roof only, no sides. What kind of foooting do I need around the peremiter? 12"X12", 18"x18"?

I am in east Texas so no frost/freeze. Does anyone here know?

Thanks,
Rick
 
Last edited:
/ Question about footings
  • Thread Starter
#4  
It's a hard sand, not red sand the yellow sand. Loose sand will get very hard here after a good rain. So sand/clay.
 
/ Question about footings #5  
check with local contractors and see what is the norm for the locaton...
 
/ Question about footings #6  
With "no sides" on your structure all the weight will be bearing on your posts,right? If that be the case,you do not need a perimeter footer.
 
/ Question about footings #7  
I am wanting to build a 20x40 concrete pad 4" with a metal roof only, no sides. What kind of foooting do I need around the peremiter? 12"X12", 18"x18"?

I am in east Texas so no frost/freeze. Does anyone here know?

Thanks,
Rick

Posts in the ground or on the slab?
 
/ Question about footings #8  
The footing size would be determined by the loading.:D

What kind of soil? Compacted or loose?

It should depend on the two above. I just poured a 12ft X 28ft foundation a couple of weeks ago and we went 18 inches wide based on the soil and building load.
 

Attachments

  • PondCoop 001.jpg
    PondCoop 001.jpg
    149.4 KB · Views: 192
/ Question about footings #9  
Mousefield:

Just curious, what is the slab inside the one end of the footing for?
 
/ Question about footings #11  
Mousefield:

Just curious, what is the slab inside the one end of the footing for?

After we framed the out side foundation we decided to make an 8ft X 12ft room, so the pad is that area. We will fill in the three side to make it solid to the outside foundation. We had to leave the 6 inch gap to get the framing wood out. It's called hindsight. :laughing:
 
/ Question about footings #13  
I am wanting to build a 20x40 concrete pad 4" with a metal roof only, no sides. What kind of foooting do I need around the peremiter? 12"X12", 18"x18"?

I am in east Texas so no frost/freeze. Does anyone here know?

Thanks,
Rick

Rick, If I were you I would call your local concrete company and tell them what you intend to use it for and then ask them about the type footers you need , I am assuming there is no building permit required and no building code office..but if there is , then you could call your local code office and ask them what the code is ...if you are going to permit it...:)
 
/ Question about footings #15  
Rick for the type of structure you want the easiest thing to do is build it like a pole barn. Set your poles, build your roof and then come in and pour a slab. The slab will be a floating or sometimes called an Alaskan slab. Along the edges you dig a trench, in this case 8 or 10" deep would be enough, that slopes at 45 degrees to the main body of the floor.

MarkV
 
 
Top