Ditch Witch C99

[BeaconWoods]

Hi Dave,
This is Don Young. Did you get my PM request for a copy of your manuals for the C99? I couldn't tell if it got sent or not. I'll try sending it again just to be sure. Thanks, Don

Hi Don,

Just noticed the activity. Still looking for the manuals? I can send them if you like. I have them all, including the engine parts and service manuals.

Gary N.

 

[skaterboi3436]

Still need them? I have all the manuals including the engine.

I need the Manuals for the C99 ditch witch if you Still have them.. Brandon.13_2007@yahoo.com

 

[BeaconWoods]

On their way.

 

[GIBSON GUY]

In the mail!

Hello daveshhoot. It's been awhile since you last did it, but would it be possible to send me a copy of the Ditch Witch C99 operator's manual. Thank you . - gibsonguy1954@gmail.com

 

[GIBSON GUY]

On their way.

On their way.

Hi BeaconWoods. Would it be possible to send me a copy of the manual please? I replied to Daveshoot and didn't think it was sent, but I see now that it was. Thanks to either of you fellas! - gibsonguy1954@gmail.com

 

[BeaconWoods]

I need the Manuals for the C99 ditch witch if you Still have them.. Brandon.13_2007@yahoo.com

On their way.

 

[AZdigger]

It’s been a fun rebuild so far.

We have different ideas of fun . I have zero patience for this kind of work but I'm persistent . A year and a half later I am back at it.

I fixed it enough to do a couple hundred feet of trenching at my house and then parked it. I think I'm going to attempt to take the planetary gear apart and see if I can get it into drive. It's too heavy to push/pull around. It started right up after sitting for 18 months through two AZ summers. I stopped in here for a refresher course.

 

[BeaconWoods]

We have different ideas of fun . I have zero patience for this kind of work but I'm persistent . A year and a half later I am back at it.

I fixed it enough to do a couple hundred feet of trenching at my house and then parked it. I think I'm going to attempt to take the planetary gear apart and see if I can get it into drive. It's too heavy to push/pull around. It started right up after sitting for 18 months through two AZ summers. I stopped in here for a refresher course.

What kind of drive issues are you having? On mine, the planetary gearbox is welded together. The problem was that the part that was supposed to engage it would pop out. The box would spin a turn, then re engage for a short bit, then pop out again. A bit of grinding to change the angle to keep it engaged did the trick.

 

[Ernsay]

Hey I swear I have been looking all over for the maintenance manual for this thing! I have a C99 down right now because one of the drive axle bearings broke off the bracket that held it to the body and bent all up on me. Can't figure out how to get those retainer rings off the axle rod. If you see this can you send a copy of the maintenance manual to Ernie.godin0453@kirtland.edu ? Thanks!

 

[BeaconWoods]

Should be there by now. Let us know how it turns out.