GreatWhitehunter
Veteran Member
No, I don't think I'd put a hammer on a machine I own, to much stress on the pins.
splitting rock
- Thread starter old gray
- Start date
- Views: 15320
No, I don't think I'd put a hammer on a machine I own, to much stress on the pins.
ultrarunner
Epic Contributor
- Joined
- Apr 6, 2004
- Messages
- 29,749
- Tractor
- Cat D3, Deere 110 TLB, Kubota BX23 and L3800 and RTV900 with restored 1948 Deere M, 1949 Farmall Cub, 1953 Ford Jubliee and 1957 Ford 740 Row Crop, Craftsman Mower, Deere 350C Dozer 50 assorted vehicles from 1905 to 2006
My thoughts too... just wondering if you did.
The guys around here seem to mostly have them on Excavators of all sizes and large Backhoe.
Off topic... one day I hope to have a post hole auger on my Deere 110 Backhoe... it would be sweet and I have a lot of holes to drill at my brothers place and not much of it is flat.
The guys around here seem to mostly have them on Excavators of all sizes and large Backhoe.
Off topic... one day I hope to have a post hole auger on my Deere 110 Backhoe... it would be sweet and I have a lot of holes to drill at my brothers place and not much of it is flat.
GreatWhitehunter
Veteran Member
Me too, I actually found a deere pa 30 used forsale but it was still 1k more than the 3pt model.
I realize there are alot of pro's over a 3pt version but for the frequency I seem to use them a grand is hard to swallow.
Matt
Well late getting back here but the SDS drill from HF worked fairly well. I bought some feathers and wedges and lost them. I think it would have worked out but I ran out of time, needing to get the slab poured so I went around one rock and shortened the width up by
2 feet.I have more rocks to deal with at another time.
2 feet.I have more rocks to deal with at another time.
