JD loader control repair

[JoeArkansas]

After replacing the loader control pistons (spools) and after putting the assembly back on the tractor they seemed to be reversed even though I was careful to put the cables back on the same side as removed. Pushing the joystick forward now dumps the bucket instead of lowering the bucket as before. If anyone has had similar experience please tell me what you did to correct it?? Thanks,J

 

[Harry in Ky]

Go back and try again. You either crossed the controls or the hoses. If it works, only backwards on the controls you haven't damaged anything, just crossed something up.

 

[kennyd]

You either crossed the controls or the hoses.

^^^^
THIS.

This issue can only happen externally.

 

[Tx Jim]

Sounds as if hoses that lead to cylinders were attached to valve body incorrectly.

 

[JoeArkansas]

Go back and try again. You either crossed the controls or the hoses. If it works, only backwards on the controls you haven't damaged anything, just crossed something up.

Thanks, ill try that.