Help - Rolled my JD4710.

[slingworks]

When I was still living at home we used an H with a "loader" (manure scoop) to load round bales on truck. On one bale, the loader "swung" to the right a few inches and was just enough of a shift to make the tractor roll onto it's side. This was in a flat hayfield. We just used the truck (a 1/2 ton at that) with a bale in the back and a cable. Hooked it high on the wheel and gave a slow steady pull. Everything righted up. If you place your chain/cable up high somewhere it will come over with less force required than you might think. Might even be able to use a come-a-long with a chain or cable?

An H w/loader is probably similar in weight to your tractor.

 

[Jaygyver]

Remember, you're not lifting the full #4000 Lbs, you're only rolling at most #2000 lbs.
I did the same thing with my little JD-770 with the loader and brush cutter on many moons ago. Mowed over the same dang area for years but decided to move over another foot and found a hole I'd never seen before. Not as bad of an incline as yours but close. Only my problem was I was on a slope and tipped onto a flatter area and when I tipped it back up I was still on the slope.

I had no problem rolling it back up with my bronco and a strap. I lucked out as it was only on it's side for a couple of hours so while I was thinking what to do after I got it up the oil had time to drain back and I just started it back up and was able to maneuver just enough for flat ground with the strap still on just in case.

Years later the neighbors contractor when he built his house tipped his mini excavator over and asked me if I could pull it out but I told him my tractor was too light and just use his truck and a strap to tip it back up and it worked great.

 

[dodge man]

At this point the OP has the tractor upright and his last post was how to drag the backend around so it’s headed uphill. I wouldn’t be surprised if he doesn’t have it running by now

 

[henerythe8th]

I'm pretty sure that i could get that tractor back on its wheels and deal with it afterwards.

BUT

I WOULD HIRE A WRECKER!