Gravel question

   / Gravel question #1  

Capstone

New member
Joined
Jul 23, 2019
Messages
19
Location
Kaufman, TX
Tractor
LS MT125
Anyone know what type of gravel the state (Tx in my case) uses for asphalt roads.

I see large piles all the time on the side of the road. Usually dark grey and almost black sometimes. I assume they use it to mix for road building.

Looks 1” or less and very uniform size.
 
   / Gravel question #2  
Sounds like maybe it is ground-up asphalt removed from the road before paving. ?

Bruce
 
   / Gravel question #3  
Anyone know what type of gravel the state (Tx in my case) uses for asphalt roads.

I see large piles all the time on the side of the road. Usually dark grey and almost black sometimes. I assume they use it to mix for road building.

Looks 1” or less and very uniform size.

Why you buy asphalt, you specify the mix. Always go with the state highway mix. Contractors sell it and install it, but if you don't have in writing what the mix is, they will give you a cheaper mix and increase their profit.
 
   / Gravel question #4  
Piles on side of road are for seal coat applications.
Spread hot liquid asphalt, and distribute the rock on top. Sweep off excess.

Not exactly sure what it is called
 
   / Gravel question #5  
Piles on side of road are for seal coat applications.
Spread hot liquid asphalt, and distribute the rock on top. Sweep off excess.

Not exactly sure what it is called

Here they call that chip and seal.

It's limestone chips here, because limestone is cheap and local.
 
   / Gravel question #6  
Most all the secondary county roads, around here, use some form of crushed basalt and a smaller material - the size of rock salt. It's a mix. The big 'ol gravel trucks will dump a loooooong pile - right down the center of the road. The asphalt truck follows right behind - saturating this long pile. It's then spread and rolled. Locally this is called - chipseal.

This was done to the county road right here. After a couple two or three months it was still painful to walk on barefoot. The crushed basalt was sharp as razors.
 
   / Gravel question #7  
<snip>
This was done to the county road right here. After a couple two or three months it was still painful to walk on barefoot. The crushed basalt was sharp as razors.
Bet it smooths your tires also.
 
   / Gravel question
  • Thread Starter
#8  
IMG_3546.jpg
IMG_3547.jpg
IMG_3548.jpg
Here’s what I’m seeing. I’m thinking about putting it down over a crushed concrete base if I can find a source.
 
   / Gravel question #9  
Yes, chip n’ seal a term used for it.

No/little fines in this material generally, won’t ever pack and setup above a hard base.
 
   / Gravel question
  • Thread Starter
#10  
Yes, chip n’ seal a term used for it.

No/little fines in this material generally, won’t ever pack and setup above a hard base.

I see your point about it not setting up without fines.
 

Tractor & Equipment Auctions

(2) Firestone 460/85R30 Tires and Rims (A50120)
(2) Firestone...
2012 Caterpillar AT1055E Track Asphalt Paver (A51691)
2012 Caterpillar...
2019 Chevrolet Silverado 1500 4x4 Crew Cab Pickup Truck (A50323)
2019 Chevrolet...
1996 International 4700 Bucket Truck (A50323)
1996 International...
Assortment of Light Poles (A50121)
Assortment of...
Homemade Flatbed Tilt Trailer (A50322)
Homemade Flatbed...
 
Top