Full figured 25hp Tractors

[Patches]

No regrets at all on my 25 hp Branson . I did have to learn what gear to be in when working with different implements but it has done everything I’ve asked of it . They say after your warranty is up you can turn the HP up to around 35 hp. Not sure I’ll do it when the time comes . This project alone saved me over 5K. I got 7 quad axle loads spread in one weekend.

How did you get away with filling that wetland?

 

[tacticalturnip]

How did you get away with filling that wetland?

By not living in Maine, or perhaps he just went and did it.

 

[DGZRT]

How did you get away with filling that wetland?

It use to be planted pines . When they were removed and the stumps ground . 178 of them ! Low spots formed . The rain runs away from the house and pooled until we had a pond of mush. It use to be dry when all the trees were there. The mess was unbelievable when all the snow melted.

 

[DGZRT]

It would be interesting if we could figure out a way to do a practical comparison of your 2515H and my L2501 from the viewpoint of actually owning and using them.

Comparison chart posted by a dealer: https://www.kenotractors.com/wp-content/uploads/2020/03/2515R-2515H-Comparison-Chart.pdf According to the chart, the 2515 has a loader lift capacity of 2,200 lbs vs 1131 for the L2501. That is a substantial difference.

Also looks like the 2515 has a suspension seat and a fuel tank located at the foot rest area so no lifting 5 gallon cans up to the hood like my L2501.

A lot of my decision came down to money and dealer . The Kioti was my first choice and I would love a Kubota but the funds weren’t there. I found a good Branson dealer 28 miles from me with a good service department and that made my decision.

The specs , features, motor and warranty are very good . If I were to upgrade I would stick with Branson .
It’s used strictly on weekends up at our cabin . I just couldn’t justify 35k for a green tractor would I like one YES . Ha ha

 

[Patches]

It use to be planted pines . When they were removed and the stumps ground . 178 of them ! Low spots formed . The rain runs away from the house and pooled until we had a pond of mush. It use to be dry when all the trees were there. The mess was unbelievable when all the snow melted.

178; Thats a lot of holes. Probably still couldn't do it here, especially if you have any critters taking up residence, like salamanders or peepers and such. They call them "vernal pools" and even if they dry up during the summer, you can't touch them. Back to the subject at hand----

 

[Jchonline]

There is a TYM dealer in my area who has recently begun promoting the Branson 2515H heavily. I don't think he was selling Branson before the merger, but he's really promoting 2515s now. I don't have any inside information whether TYM is trying to clear our Branson models or if they really intend to keep selling this particular model. But it looks like the TYM dealer has jumped in with both feet to sell them.

As for the 2515H, my impression is that it has really good loader capacity and hydraulics, but it's still a 25hp tractor when it comes to operating a rotary cutter. If the OP primarily needs loader capacity and not HP for mowing, then certainly the OP should consider that model.

Just trying to reduce the inventory. That isnt a good thing, to me it means they are trying to end the line.

 

[crashz]

Love my L2501, but lack of PTO power is the one complaint I have. Now that I'm out of warranty I might change that, but it can be a real drag when your rotary cutter starts bogging down.

 

[Williy]

Anyone financing a tractor get the lowest payments
as you can always make 2, 3 or more payments at
one time but if you get in a bind that low payment will
look mighty good! Also paying it off early saves interest
If you go for the short term and high payments like $671
or similar for most folks they can't double let alone triple the payments and if you get short on cash $671 is not
easy to come up with for most folks now adays

willy

 

[paulsharvey]

I think I'm going to go check out a TYM/Branson 1525H next week. They also have a 3515H for $3k more. Got to see what kind of financing is, trade in value (if they want the L285), and payment amounts. I know it's pretty low, but if I can get payments down to $300/month range, I might do it. Also will look at the Kioti and other TYM/Branson while there.

Next question; I have a Frontier 72" Box Blade. I know that's too much for my L285, and I'm sure it's too much for a 25 hp. Do you think it's worth trying out? It's a lot heavier duty then the 60" you see at Tractor supply, ect; and probably cost $1200 new. I only have I think $275 in the BB, so I'm sure I can get my money out of it; but probably not enough to cover a brand new 60" BB.

I did look at the RK25; and liked the tractor, But when you look at the rear lift arms and top link; they seemed comically light built. Not saying you can visible tell how strong they are, but it sure looked like a weak point.

 

[2manyrocks]

There is a specific thread discussing various opinions on the 2515H. General thoughts on the 2515h?

At least one member has bought one. It would be smart to ask someone who actually owns one what their opinion is.

 

[Torvy]

TYM makes that RK as well, but it is a subcompact. That is an entire class smaller than the '2' series TYM tractors. Putting that in perspective, the 2515 3pt can lift nearly 2X that of the T25 (same as RK25). It was about 1100 lbs more (rops).

Enjoy the ride!

 

[CloverKnollFarms]

Tony's Tractor Adventures just got a 2515 to put through its paces. He provides great content

 

[tacticalturnip]

Tony's Tractor Adventures just got a 2515 to put through its paces. He provides great content

I've watched two of them so far, and he really seems to be enjoying it.

It sure is a sight bigger than his T25.

 

[DGZRT]

This Implement Is a beast on the 2515h

 

[paulsharvey]

Stopped by this afternoon and looked at the Kioti 2610H and TYM/Branson 2515H. For some reason, I really thought the Kitou was going to be a lot smaller, but side by side, almost exact same size. Also looked at the TYM/Branson 3515H, and the TYM T264. The Kioti was $20,500 and the 2515 was $22,000. 3515H was $26,000.

I feel like I should look at the MF 1526, but the specs aren't awesome inspiring. I think it's of similar scale to the T264 in size.

Asked about trade ins. Yes, they take them. but he said honest price they would give is $600-1000.

 

[2manyrocks]

You could take a look at www.tractorhouse.com to see what other tractors, including used ones, are for sale near you to see what your other options might be for buying. You can also check for L285 auction results to see what they have been selling for at auction.

 

[tacticalturnip]

The Massey 1526 is a nice machine, but it certainly is smaller in size, weight, and capability compared to the larger machines. Still, it's worth looking at; who knows, it might be the right size for you.

With regards to the Kioti, I did quite appreciate just how much customization is available right from the start. There is no open station CK2610SE, but I outfitted my tractor as close as I could get.

 

[paulsharvey]

That probably includes "Insurance". KATAC was almost $200/month for my M4, no freaking way.

After I left dealer, and made a U turn on 4 lane; I called back to ask about insurance prices. He said for a roughly $20,000 package; expect insurance to be approx $1800 over life of the 60 month loan.

 

[paulsharvey]

You could take a look at www.tractorhouse.com to see what other tractors, including used ones, are for sale near you to see what your other options might be for buying. You can also check for L285 auction results to see what they have been selling for at auction.

I've seen similar on FB Marketplace for around $2500. Which is kinda what dealer said; he would probably put it on the lot at $2-4k depending on appearance; and offer me about 1/2 of that. I was honest with him, runs, drives, looks like heck. He said probably sell it for $2k and trade in of $1k. He was straight up about being better for me to do a private party sale. I just hate the selling process.

If I was smart (big IF); I would go ahead and sell the L285 now, as I'm looking for something new.

 

[paulsharvey]

I made a deal with 17 y/o son; if he handles selling the L285; everything over $1500; I will split 50/50 with him. I also have a 5ftx10ft steel deck landscape trailer, that I upgraded from; told him everything over $500; I will split with him 50/50; but he handles all the BS of selling.

Have I mentioned I Hate selling stuff...