96 Pantry and 8 Ceiling

   / 96 Pantry and 8 Ceiling #12  
No cutting can happen as they are pre-finished cabinets.

Cabinet is 91 and 9/16 tall, the base is 5 and 5/16 then the base sets up inside the bottom of the cabinet by 15/16?

Fill in that 15/16" in the bottom, the build a new base with a 1/4"gap to allow for shimming, etc. Put the base down, slip the back edge on, then slide it back. You may have to vertical lift the cabinet. Raise it up in steps to get the cabinet higher than the base.

I built my panrty in two pieces because I did not want it on a base. Just lifted upper on once the bottom was secured to the wall. Jon
 
   / 96 Pantry and 8 Ceiling
  • Thread Starter
#13  
Thanks for the suggestions!!

I cut most of the left side of the cabinet off and we were able to work it into place.

In retrospect I should have cut the left side off flush and it would have been easier to do, since all the force once stuff is in the cabinet is pushing down on the floor of the cabinet which is on the base.
 

Attachments

  • Cabinet installation 1 web.gif
    Cabinet installation 1 web.gif
    4.4 MB · Views: 209
   / 96 Pantry and 8 Ceiling #14  
Looks like it fits there perfectly!!!
 

Tractor & Equipment Auctions

New Kivel 3500 lb. Skidloader Forks (A50775)
New Kivel 3500 lb...
2017 Ford F-150 Pickup Truck (A54814)
2017 Ford F-150...
2018 MACK CHU613 DAYCAB (INOPERABLE) (A55745)
2018 MACK CHU613...
2012 CATERPILLAR 279C2 SKID STEER (A51242)
2012 CATERPILLAR...
JOHN DEERE 648R LOT NUMBER 105 (A53084)
JOHN DEERE 648R...
2010 Ford Edge SE SUV (A51694)
2010 Ford Edge SE...
 
Top