Zd1211 blades

   / Zd1211 blades #71  
I’d think it would take a serious hit on the mower to bend or warp a 1/4” thick blade.

My stock Kubota blades brand new will not lay flat on the table or bench best I remember.

Both these Oregon blade cutting edges are strait & flat
 
   / Zd1211 blades #72  
I’m doing my 250 hr service tomorrow and putting on the machined hub for the 1.125 blades.
I’ll give a report tomorrow night.
 
   / Zd1211 blades #73  
I’m doing my 250 hr service tomorrow and putting on the machined hub for the 1.125 blades ...

I bought 4 new (1 for spare) K5955-34380 spindle boss blade holders & had machined down for my 72” SD to accept the Oregon G6 Gator Blades like I’m running on my 72” RD Deck.

These Blades are Awesome.

Thanks Again to gonnasellit for his R&D work :thumbsup:
 
   / Zd1211 blades #74  
5BC2F633-F205-4577-A944-9DBDB1845F04.jpegView attachment 659083

Here’s the pic
 
Last edited:
   / Zd1211 blades #75  
I have a hard time getting pics to upload from my phone.

IDK what I’m doing wrong :(
 
   / Zd1211 blades #76  
Sorry for not getting back sooner on the blade swap.
I’ve put about 10hrs on my 1211 since I put the machined hubs and Oregon Gator G6 blades on. It definitely made a + difference in the cut quality, it also
Is leaving a definitely noticeable stripe.
 
   / Zd1211 blades #77  
Buckeyebutch, is your ZD1211 a 72” Deck ?
 
   / Zd1211 blades #79  
Sorry for not getting back sooner on the blade swap.
I’ve put about 10hrs on my 1211 since I put the machined hubs and Oregon Gator G6 blades on. It definitely made a + difference in the cut quality, it also
Is leaving a definitely noticeable stripe.

When you say stripe are you referring to the desirable contrast stripes, or some defect in the cut?
I have been very satisfied with G6 Gator blades on my ZD mowers, but with the 1-1/8" holes. I can't believe Oregon has not made a blade to fit the new Kubota commercial mowers.
 
   / Zd1211 blades #80  
I’m sure he means the desirable contrast stripes from mowing back & forth. :thumbsup:

I agree with you on Oregon loosing out on not getting in on the SD Decks running the 1-5/16” center hole blades.

Especially with them being the exact same length.
 

Tractor & Equipment Auctions

2016 PETERBILT 579 TANDEM AXLE SLEEPER (A51219)
2016 PETERBILT 579...
PAIR OF TALL STACK PIPE RACKS (A50854)
PAIR OF TALL STACK...
2011 Chevrolet Colorado LT Pickup Truck (A50323)
2011 Chevrolet...
2012 BIG TEX PIPE TRAILER (A50854)
2012 BIG TEX PIPE...
Hayrack (A50515)
Hayrack (A50515)
2018 East Texas 20ft Utility Trailer (A49461)
2018 East Texas...
 
Top