Show What Tool You Made*

   / Show What Tool You Made* #461  
My imagination went into build mode again .I have a transmission to change in my pickup so I decided to build a jack .No test run yet so will wait and see how it works out .
 

Attachments

  • 20161114_120009_HDR.jpg
    20161114_120009_HDR.jpg
    4.3 MB · Views: 772
   / Show What Tool You Made* #462  
sorry that picture went in upside down not sure what I did wrong ,or why and can't figure out how to fix it.
 
Last edited:
   / Show What Tool You Made* #463  
sorry that picture went in upside down not sure what I did wrong ,or why and can't figure out how to fix it.

Your picture comes up alright. I like the idea of the hex bolt on the end of the screw.
 
   / Show What Tool You Made* #464  
My imagination went into build mode again .I have a transmission to change in my pickup so I decided to build a jack .No test run yet so will wait and see how it works out .
How does it tilt? Tranny jacks need to tilt two ways.
hugs, Brandi
 
   / Show What Tool You Made* #465  
It was a spontaneous build ,no tilt was planned , if I get lucky it will have enough flex where the top rotates for the tilt
 
   / Show What Tool You Made* #466  
Couple wood shims pushed in under the trans pan will tilt it , I am spontaneous also. I like it , sure beats dragging in up on your chest and knees and working it up there.
 
   / Show What Tool You Made* #467  
Couple wood shims pushed in under the trans pan will tilt it , I am spontaneous also. I like it , sure beats dragging in up on your chest and knees and working it up there.
YEP!! That's nothing you can't cure with some wooden shingles and a couple of ratchet straps
 
   / Show What Tool You Made* #468  
Thanks for the compliments . I lost the ability to wrestle it by hand about30 yrs ago.
 
   / Show What Tool You Made* #469  
Here is something I made a long time ago to hold onto a small screw in tight places to poke it through a hole.
 

Attachments

  • screw-holder1.jpg
    screw-holder1.jpg
    6.3 MB · Views: 635
   / Show What Tool You Made* #470  
Here is something I made a long time ago to hold onto a small screw in tight places to poke it through a hole.

That's nice-
I usually make something on the spot- a piece of shirt cardboard, or use something like a hemostat, but it can be dicey- and your tool looks like it has a pretty positive hold on the machine screw- especially important in the usual locations I'm working in- where if you drop it, it's prolly gone for good...

Thanks for sharing,
Thomas
 

Tractor & Equipment Auctions

2021 Ver-Mac PCMS-3812 Solar S/A Towable Trailer Message Board (A49461)
2021 Ver-Mac...
2020 JOHN DEERE 332G (A50854)
2020 JOHN DEERE...
2018 FREIGHTLINER 1085D DUMP TRUCK (A51406)
2018 FREIGHTLINER...
2005 GROVE RT700E ROUGH TERRAIN CRANE (A50854)
2005 GROVE RT700E...
Lincoln Electric Vantage 300 Welder/Generator (A49461)
Lincoln Electric...
2017 JOHN DEERE 624K-II WHEEL LOADER (A51242)
2017 JOHN DEERE...
 
Top