Show What Tool You Made*

   / Show What Tool You Made* #461  
My imagination went into build mode again .I have a transmission to change in my pickup so I decided to build a jack .No test run yet so will wait and see how it works out .
 

Attachments

  • 20161114_120009_HDR.jpg
    20161114_120009_HDR.jpg
    4.3 MB · Views: 771
   / Show What Tool You Made* #462  
sorry that picture went in upside down not sure what I did wrong ,or why and can't figure out how to fix it.
 
Last edited:
   / Show What Tool You Made* #463  
sorry that picture went in upside down not sure what I did wrong ,or why and can't figure out how to fix it.

Your picture comes up alright. I like the idea of the hex bolt on the end of the screw.
 
   / Show What Tool You Made* #464  
My imagination went into build mode again .I have a transmission to change in my pickup so I decided to build a jack .No test run yet so will wait and see how it works out .
How does it tilt? Tranny jacks need to tilt two ways.
hugs, Brandi
 
   / Show What Tool You Made* #465  
It was a spontaneous build ,no tilt was planned , if I get lucky it will have enough flex where the top rotates for the tilt
 
   / Show What Tool You Made* #466  
Couple wood shims pushed in under the trans pan will tilt it , I am spontaneous also. I like it , sure beats dragging in up on your chest and knees and working it up there.
 
   / Show What Tool You Made* #467  
Couple wood shims pushed in under the trans pan will tilt it , I am spontaneous also. I like it , sure beats dragging in up on your chest and knees and working it up there.
YEP!! That's nothing you can't cure with some wooden shingles and a couple of ratchet straps
 
   / Show What Tool You Made* #468  
Thanks for the compliments . I lost the ability to wrestle it by hand about30 yrs ago.
 
   / Show What Tool You Made* #469  
Here is something I made a long time ago to hold onto a small screw in tight places to poke it through a hole.
 

Attachments

  • screw-holder1.jpg
    screw-holder1.jpg
    6.3 MB · Views: 635
   / Show What Tool You Made* #470  
Here is something I made a long time ago to hold onto a small screw in tight places to poke it through a hole.

That's nice-
I usually make something on the spot- a piece of shirt cardboard, or use something like a hemostat, but it can be dicey- and your tool looks like it has a pretty positive hold on the machine screw- especially important in the usual locations I'm working in- where if you drop it, it's prolly gone for good...

Thanks for sharing,
Thomas
 

Tractor & Equipment Auctions

2020 MACK PINNACLE (INOPERABLE) (A50854)
2020 MACK PINNACLE...
2020 CATERPILLAR 289D3 SKID STEER (A51242)
2020 CATERPILLAR...
2017 FREIGHTLINER 126 SLEEPER TRUCK (A51222)
2017 FREIGHTLINER...
2012 Ford F-150 Crew Cab Pickup Truck (A49461)
2012 Ford F-150...
2015 FREIGHTLINER  CASCADIA (INOPERABLE) (A50854)
2015 FREIGHTLINER...
2006 International 9400i (A51039)
2006 International...
 
Top