Quick-Tatch disassembly help

rtm038 · Aug 24, 2010

Hey all,
I need to remove the pivot/push beam (#30) from the A-frame (#27) on a front Quick-Tatch set-up. So far I've removed the main pivot bolt (#33 below), but can't get the bushing (#32) out. Does anyone know how to get this bushing out?

Thanks
Ryan

kennyd · Aug 24, 2010

No clue on that one! Is it damaged?

rtm038 · Aug 25, 2010

Figured it out. I needed to hit the backside of the push beam with a mallet a few times to get it slide off the A-frame.

Ryan

jimgerken · Aug 25, 2010

Are you rebuilding it to tighten it up a bit? Mine's sure sloppy and that thought has crossed my mind.

bronzebeetle · Nov 9, 2019

With the bolt removed and item 27 is separated from item 30 you should be able to drive out the bushing or preferably, press it out with a hydraulic press.

kennyd · Nov 10, 2019

bronzebeetle said:
With the bolt removed and item 27 is separated from item 30 you should be able to drive out the bushing or preferably, press it out with a hydraulic press.

That was 9 years ago...hope he fixed it by now LOL.