Question about I-Mig design

   / Question about I-Mig design #1  

Haywire

Veteran Member
Joined
Nov 20, 2010
Messages
1,047
Location
Central Kentucky
Tractor
Tractorless :(
I'm looking at Mig welders and have a question on Everlast's I-mig.

Why does the Mig power cable come through the faceplate to hook up on the outside? Why couldn't that be an internal connection?

Ian
 
   / Question about I-Mig design #2  
I think I know what your talking about. Maybe for whatever reason to keep the wireing close to the switch.
 
   / Question about I-Mig design
  • Thread Starter
#3  
The negative lead is what I'm wondering about.

attachment.php
 

Attachments

  • Untitled.jpg
    Untitled.jpg
    39.6 KB · Views: 213
   / Question about I-Mig design #4  
Strange? Looks like a twist connect for transporting, but would still be attatched tho. Gotta be for a reason, weird?
 
   / Question about I-Mig design #5  
Ian,

That is, or rather should be the positive lead actually. Whoever took the picture put it in the negative hole, as if you were going to flux core with it. The Work clamp is hooked into the other DINSE connector.

This is actually, in my book preferred, because no tools needed to swap polarity, and it allows easy access to to be able to weld stick.
 
Last edited:
   / Question about I-Mig design #6  
Ah ha! Hard to see on my phone. Makes sense.
 
   / Question about I-Mig design
  • Thread Starter
#7  
Ok, that makes sense.. easy to switch polarity on the fly.

thanks,
Ian
 

Tractor & Equipment Auctions

2016 PETERBILT PB337 FLATBED TRUCK (A52706)
2016 PETERBILT...
Brent 420 Grain Cart (A55302)
Brent 420 Grain...
2013 Buick Enclave SUV (A55853)
2013 Buick Enclave...
Ford F450 Bucket Truck with Altec AT200A Boom (A55302)
Ford F450 Bucket...
2013 Cheverolet Impala 1FL Sedan (A55853)
2013 Cheverolet...
Two Post Car Lift (A50120)
Two Post Car Lift...
 
Top