Joined to get some help with a 1983 John Deere 318 I recently purchased, I want to change the engine oil and can't find drain plug. I watched some You Tube videos and all that I found had a access hole on right side of engine with a drain valve, I don't have that hole. Any help would be appreciated thank you.
New Member
- Thread starter col6365
- Start date
- Views: 890
TBN Support
TBN Support
- Joined
- Feb 4, 2015
- Messages
- 4,560
:welcome:
Welcome to the forum!
I'm going to move this thread over to our John Deere section to see if we can find you some advice.
Welcome to the forum!
I'm going to move this thread over to our John Deere section to see if we can find you some advice.
beenthere
Super Star Member
- Joined
- Aug 16, 2001
- Messages
- 18,658
- Location
- Southern Wisconsin, USA
- Tractor
- JD_4x2_Gator, JD_4300, JD_425, JD_455 AWS, added JD_455, JD_110, JD_X485(sold)
Thomas
Epic Contributor
- Joined
- Apr 6, 2000
- Messages
- 32,314
- Location
- Lebanon,NH.
- Tractor
- Kubota B2650HSD w/Frontloader & CC LTX1046 & Craftman T2200 lawn mower.
:welcome: to TBN...enjoy.
Zebrafive
Super Member
TBN Support
TBN Support
- Joined
- Feb 4, 2015
- Messages
- 4,560
Whoops. You're correct. I saw 1983 and ran with it.
:tractor: Here's one more move for this thread....
Amvcane
Platinum Member
- Joined
- May 24, 2013
- Messages
- 664
- Location
- NEPA
- Tractor
- 2012 Kioti CK35hst tlb; 1988 JD 420; 1990 JD 322; 1987 JD 332; 1985 JD 318; 2010 JD ProGator 2030A;
Col6365, welcome to the forum.
There is an access hole in the tractor frame on the right side just above the tie rod. Brass valve and nipple. I put a 6” long piece of tubing on the nipple, I think it’s 5/8”, and open the valve with a pair of needle nose pliers. Many revolutions till oil comes out.
There is an access hole in the tractor frame on the right side just above the tie rod. Brass valve and nipple. I put a 6” long piece of tubing on the nipple, I think it’s 5/8”, and open the valve with a pair of needle nose pliers. Many revolutions till oil comes out.
Thanks for the help I was able to figure it out, the oil plug was replaced with an expandable rubber frost plug type. I did get it out only to find that the threads in oil pan are damaged. Looking into repair options that I can do with out pulling engine hopefully. My 318 doesn't have that extra side hole for the brass valve.
