sriddle1
Silver Member
- Joined
- Apr 2, 2014
- Messages
- 229
- Location
- SW New Hampshire
- Tractor
- ACTIVE: JDX730 DAYS GONE BY: JD3010, JD790, JD425
Purchased a used '21 Plain Jane Rear Wheel Drive X730 and ready to perform the next scheduled maintenance, I have 210 hours on it. I ran into some terminology that has me a bit confused since I'm not familiar with all the X730 variants. I'm planning to perform a Hydraulic Fluid change, I have the Filter and 2 Gal and 1 Qt of Hy-Guard Low Vis. The manual (page 59), Under Section: "Changing Transaxle Oil and Filter (Except Full-Time Four Wheel Drive (HFWD) System" it further states:
9. Remove dipstick. Add John Deere Low Viscosity Hy-Gard™ (J20D) transmission oil through dipstick fill opening:
I guess I don't know what is meant when they state Two-Wheel Steer above, for sure mine is not a HFWD, any clarification would help. BTW, the X730 Maintenance Reminder states 7 qts.
9. Remove dipstick. Add John Deere Low Viscosity Hy-Gard™ (J20D) transmission oil through dipstick fill opening:
Item | Measurement | Specification |
All Four-Wheel Steer Transaxle Oil | Capacity | 5.7 L (6.0 qt) |
All Two-Wheel Steer Transaxle Oil | Capacity | 7.7 L (8.1 qt) |
I guess I don't know what is meant when they state Two-Wheel Steer above, for sure mine is not a HFWD, any clarification would help. BTW, the X730 Maintenance Reminder states 7 qts.