OP
ptsg
Super Member
Well, that's the max depth it goes. 400 mm.
I've put a good amount of use on it. So far so good. Tractor pulls it very nicely.
Homemade 2 shank subsoiler
- Thread starter ptsg
- Start date
- Views: 21727
I've put a good amount of use on it. So far so good. Tractor pulls it very nicely.
jyoutz
Super Member
Take a look at the spacing on my implement. It has 9 shanks and is 7’ wide. The shanks can be sunk 17” deep.
OP
ptsg
Super Member
That's a chisel plow, used for a little bit different purpose. At the time, I considered getting one of those instead of building the subsoiler.
Subsoiler also ended up suiting this soil a lot better. A chisel plow would have barely scratched the surface, now that I've seen how the subsoiler behaves.
sixdogs
Super Star Member
- Joined
- Dec 8, 2007
- Messages
- 13,765
- Location
- Ohio
- Tractor
- Kubota M7040, Kubota MX5100, Deere 790 TLB, Farmall Super C
That is incredible that you made this and got it right. Very nice.And it's done! Still subject to some minor changes after some testing but it's done. Specially the corner of the shanks. That will most likely come out.
Any bets on how long it will take for the support stand to turn into the 3rd shank?
View attachment 804583 View attachment 804584 View attachment 804585 View attachment 804586
rgr33
Platinum Member
- Joined
- Mar 21, 2012
- Messages
- 824
- Location
- Hillsboro or
- Tractor
- Kubota B2320 LS g3033. Kubota RTV 900. Exmark Lazer Z
Great job planning and fabricating your ripper, wish I had your shop and skills
I have a single shank that I pull with my 33 hp LS, it can pull it at about 16-18 inches, but as you say, I am only interested in in breaking the hard pan down the vineyard rows
I have a single shank that I pull with my 33 hp LS, it can pull it at about 16-18 inches, but as you say, I am only interested in in breaking the hard pan down the vineyard rows
OP
ptsg
Super Member
Thank you.
I've since learned that the subsoiler really makes a big difference. Before, I had to do multiple passes with the tiller to get a decent job. The first couple ones, was a bounce fest with the tiller jumping all over the place in that hard clay.
Now I run the subsoiler a couple times first and the tiller stays planted to the ground and only need to do 2 passes to get a good finish.
I've also noticed a decent jump in how fast the olive trees are evolving over time. They seem to be happier now that the ground isn't rock hard around them and the roots can just do whatever they need to do.
