BX25D and UnderArmor

xzcVAbc5 · Nov 3, 2015

Rustyferrious said:
That doesn't sound right. Are you sure you used the correct mounting hole for the bolt? Here is an under armor installation video. Might be worth double checking. Mine U-A rides high and tight.

It should be the correct holes. I read the manual and then looked at another Youtuber and my front brackets were in the same location. Rears can only go in onle place IIRC.

Rustyferrious · Nov 3, 2015

jjsjeff said:
It should be the correct holes. I read the manual and then looked at another Youtuber and my front brackets were in the same location. Rears can only go in onle place IIRC.

Only other thing I can think of is that your rear bracket is not lifting up as high as it should. The first time I raised mine, it actually went up so far it got stuck. I had to jiggle things a bit to get it to release. I don't have a MMM, but did you set the height knob to "TOP" position when you installed the UA?

xzcVAbc5 · Nov 3, 2015

Rustyferrious said:
Only other thing I can think of is that your rear bracket is not lifting up as high as it should. The first time I raised mine, it actually went up so far it got stuck. I had to jiggle things a bit to get it to release. I don't have a MMM, but did you set the height knob to "TOP" position when you installed the UA?

Yes. However, I had to adjust the bolt behind the wheel just as mentioned in the manual. I just had to turn it more times than they mentioned.