I have a BX- 24 and was having a thought on trading up to a BX-23. Can someone talk me out of that ? I have a Curtis cab, skid plates, snowblower.

I need a new or used bagger to carry grass cuttings/etc to the garden for compost/mulch. Prefer PTO driven blower, but am open to all ideas. Saw the Protero attach. Looks good, but the price is...

Need some experienced opinions here. I bought our BX-24 with loader, belly mower, 4' tiller and backhoe about 7 years ago. It was a lightly used machine and it performed quite well. Now the...

I have a BX-24 with a 2750 front mount blower..... Is there a replacement available that will fit ? 2nd question: any after market replacement dash boards for the BX-24

Has anyone installed one with the ability to remove quickly and/or easily ?? The cab makes mine a little top heavy.

Not a tractor professional but have done minor maintenance on my BX-24. I ran it out of gas a few days ago, newbie mistake, and now I must change the fuel filters. The side facing filter I was...

Which one..... inline in a heater hose or in the block ?

What is the biggest snowblower that a BX-24 can handle ?

Any ideas ???? Kubota bx-24 Ran fine for about 4 driveways then it runs very rough barely made it back. I have been using a fuel additive already and just added more even some of the stuff in the...

Hello, Taking a survey / looking for suggestions....... Block Heater or inline heater in the lower radiator hose ???

Hi folks, So the wife decided to do a bunch of mowing with the BX24 herself, because I was out of service with a neck problem, and the mowing couldn't wait. The job, she got-er-done alright, but...

I'm getting ready to downsize next year and will no longer require my BX-24. I was hoping I could get an idea of it's value along with the attachments. My neighbor is interested in buying it...

Stalls over 2000 RPM. Will start and idle if kept under 2K. Replaced both fuel filters 2x, drained tank, cleaned, blew out lines. new fuel, treated fuel. Fuel Pump makes clicks like it's...

My BX-24 has 175 hours on it. I found a large puddle of hydraulic oil on the floor of my garage this morning where I keep it parked. I put it up on ramps, and crept under it to see what might be...

After 1100 hours on my BX I started to get a squeak in one of the rear axle bearings. I didn't think much of this since I was going to change the UDT anyway, so it seemed like a good time to...

I had a tree branch crush my BX-24, basically hitting the seat and bending the driveshaft, which then broke the rest of the way when started. There's other damage as well.....but the engine is...

I recently sold my BX, and was thinking I never told this story on TBN, and there may be some who are interested. When I bought my BX I picked it up in a 144" Dodge sprinter van. Sorry this is...

The block heater on my BX-24 died recently. The contact pins completely rotted off and there's no saving the plug or the heater. Since the heater is pressed into a freeze plug hole, I'm left to...

I have had my BX-24 for about 5 years now and love it. Wife says I love it more than her but we have been together for 40 years now so I think she is exaggerating a bit. :D I would like to...

I'm putting a shop in my barn, and the sump discharge has to go out back. I took the FEL off of my BX-24 and managed to get the trench done while working in what felt like an underground parking...

I went out to the barn and saw the entire floor covered in hydraulic oil (been sitting a couple days) and started looking for any drips. The inside of the left wheel was clean and glossy, then I...

Hi All, I am adding to a thread I started in Feb. 2012 about my tractor burning up the transmission. I am pleased to report that my local dealer has done the right thing and repaired my tractor...

HI All, I have not been a member very long, maybe a month. I bought a 2007 BX-24 and was happy with it until a problem showed up. I got the machine from our local Kubota dealer who told me they...

This is the biggest stump I have ever had to dig up. It's a yellow poplar probably over a hundred years old. Took about 6 hours total Time to dig remove and backfill. I am always amazed with what...

Changed my hydraulic oil and filter, cleaned the screen etc..at 233 hrs. Second time, first was around 50 hrs. I checked the Workshop Manual from Kubota just to be sure I remembered it right...

There I was, having a grand old time rearranging brush and the like when I suddenly lost traction... I got myself out to a clearing and found that something had physically ripped the valve stem...

I have had Bro-Tek wheel spacers on our BX-24 since we bought it, and I just wanted to shout out that they have proven a very worthwhile investment. I run chains on all four tires in the winter...

Went into woods today with Rex (the BX-24) to clear undergrowth and cut firewood for winter. I had the brush cutter on the 3-pt, and the tooth bar up front left over from an earlier job. The...

1. Locate and remove the front axle oil fill cap. 2. Locate and remove the the axle vent caps located on top of each wheel hub assembly. (Failure to remove these vents will prevent complete...

If you've left the parking brake on and now you're thinking you need new brakes, READ ON! Yup, you just ate a lot (but not all) of your brakes. If the pedal goes to the floor, this procedure...

I have yet to get my FEL to play nice and park well on my very uneven ground. This is what it did to me today :( I know it's not suppose to look like that, but that's what it took to shake the...

the fluids look fine and the radiator fan is turnig good.. is it the thermostat? Is so, can this d-level mechanic, with no special tools, fix it! What do you guys think.. thanks.. rory

Hi All, Would love to hear some opinions or experiences on using a 4' or 5' box blade on a BX24. I have some light to medium grading work to do and am favoring the 5', but am not sure and also...

Attempted to start tractor. Needle on right side gauge moved when putting ignition in warmup position (needle did not move on left gauge). When putting ignition in start position, only a click...

Hi folks I have a few y/o (still under warranty) bx 24 that has had a constant problem with several od the o-rings on the loader control leaking. I have had these things replaced three...

I just noticed my BX was running very cool. Popped the hood and noticed the spade connector on the temp sensor had separated from the sensor body. The spade was still in the receptacle on the end...

The hood on my BX-24 rubs against the front of the cowling. I can't seem to find any adjustment other than to shim the hood lift assembly by placing washers under the 4 bolts that attach the hood...

Just noticed the plastic cover over the instrument panel on my '06 BX-24 is loose on the bottom. I suspect the dealer will claim "out of warranty", but thought I would seek board wisdom before I...

My BX-24 with 690 hours appears to have a failed transmission. All service has been done at the required intervals. The rear wheel drive doesn't work in either low or high, I have no brakes, and...

My neighbor has asked for my help with some drainage issues between our properties, and the fast way would be to use the backhoe to make clean-shallow ditches. My concern is that my baby has a...

I recently bought a used BX-24 from a private party. This tractor was never stored inside. The owner did not have a mower for it and he never used the three point hitch. The problem I have is...

I have been using my backhoe to dig a seemingly endless curtain drain trench and thought it may be a good idea to operate my machine with the hood open to vent the heat. The fan still cools the...

What is the front and rear lug nut torque for a BX-24 THANKS

What RPM'S DO you cruise around at? Use the FEL? Use the rear loader?When I bought my machine the salesman said 1/2 to 3/4.

I'm having a heck of a time getting my BX-24 started on the initial startup of the day. I keep it in my garage which is under the house so it never gets that cold. I have to put the fuel throttle...

This cedar stump took me about 2 hours to dig out several weeks ago. I finally got around to moving it today. I couldn't lift it with the loader and didn't want to drag it and scrape up the...

Looking for a 9" bucket....anyone want to sell or know where to get? I understand they are not available anymore.

I am thinking of purchasing a front mount Kubota snowblower for my BX-24. I do have tire chains, and loaded rear tires. My reservation is that portions of my 80' long by 40' wide driveway have...

Does anyone know if there are any retrofit parts for the BX-24 that will allow the FEL to operate at idle such as in the BX-25? What about parts that eliminate the abrupt stop in reverse?

Here's what I'm using.

I have a BX 24 and had taken the seat off and took it to the dealer 80 miles away. The material was separating from the foam in the seat. While I was there I told the dealer the fender had...

For some reason the top link on BX-24 is very difficult to turn. The end with the securing nut is easily turned by hand but the other end is so tight I had to put it in a vice to turn it. I can't...

Hi, I finally got around to putting the new seat on my BX-24. Everything went really well until I managed to pop the spring off the seat position rod while removing the seat from the tractor...

The BX-24 appears to be strong enough, but the tires are just too small to grip the sand with this load. You can see in first photo the ratio of the tractor to boat and the pitch. In second photo...

Man is this thing heavy. Seems like a fairly serious loss in lift capacity. 86lbs !! Why is the bolt hole on the toothbar slotted? Is this to allow folding the toothbar up without completely...

So, I have posted a few messages, complaining about my BX-24 problems. First it was the electrical on the system which was causing the clock to run 24/7, logging me at 64,000 hours, then I went...

With the help of my brother-in-law, I installed a steel driveway gate and will install the opener tomorrow as all the civil work is complete. Of the two tractors, the BX-1850 did most of the work...

I mowed a field today and it got up to the 80s here in Maryland. In tall grass, with the 54 inch MMM, the gauge was running close (1/4") from the red on the 1850 (running at 2,600 RPM during...

My soil is pretty sandy, so i was hoping to use a standard 9" auger, instead of the compact tractor 6" version. I'll be setting some 4x4 posts for a deck.I was thinking the 6" version might be a...

Last week while clearing some land a small stick pop up and it broke all the fan blades off that little white plastic fan attached to the rear of the drive shaft. Local Kubota dealer quoted me...

What is the difference between the 60" mower and the "fine cut" ? My dealer tells me no difference other than thicker metal and 6". Thanks

Hi all, Unfortunately, I lost my manual for the BX-24 and am down to checking the HST filter screen for my 50 hour, but I have no clue where this is located. Could someone please let me know...

There is a used BX-23 for sale local to me here in the Santa Cruz mountains (Northern California). Details are: 2006 Kubota BX-23. 4x4. 22HP Great Condition. Everything works like new. $13,900...

Thinking of selling my BX-24 with about 65 hours on it. Any thoughts on how much it is worth??

I have a BX-24 with snow blower, box scrapper, grass catcher, skid plates, thumb and Payne forks. I took delievery the second week of Jan. 07. Due to circumstances beyond my control I have to sell...

you guys have really been helpful in my decision to purchase my new bx-24. I was wondering if i should have them load the tires. Would that be a negative for mowing? the other thing i was...

You guessed it. CRACK!

The yard project is done and I need to move my BX-24 10 miles away to our vacant lot. Ideally, my dealer will come pick it up, do the seat recall, and deliver it to my lot. Unfortunately they...

I tried this in Attachments last week and only got 1 reply. Hoping for some more help here. The finance minister has approved appropriation of funds for a Rototiller for the BX-24. So far have...

The finance minister has approved appropriation of funds for a Rototiller for the BX-24. So far have looked at the KingKutter XB and Woods GTC52 Estate Series models. Would appreciate anyones...

Hello, I am in the market to purchase a new BX-24. However, due to my area (South East New Hampshire), I am limited to 1 dealer (MB Tractor) and hence, lose the competition factor. I am...

I spent many an hour on this little project this spring. I ended up with about 45 hours on the tractor to bury 700 feet of sprinkler pipe, build 225 feet of fence, spread 40 yards of topsoil, and...

I've used my backhoe a fair amount, about 20-25 hours, and have always greased it dilligently. For the last several hours I have been hearing a loud squeak while operating it. At first it was...

When plowing snow with my fancy new Kubota BX-24 the transition while moving in reverse to stop is very abrupt. It is not this way when going from forward to stop. I previously had a BX-2230...