polaris
Member
Steve do you have a tooth bar for a john deere 73" HD bucket? Is it a direct bolt on fit? If so what is the price Thanks Polaris
Tooth Bar Pricing Guide
- Thread starter Anonymous Poster
- Start date
- Views: 2496
Steve_Carver
Approved Advertiser
sure.... approx. $310 + shipment cost.
just need the exact inside measurement ... side to side
100% satisfaction or send it back for refund
email toothbar@carverequipment.com
thanks
sc
just need the exact inside measurement ... side to side
100% satisfaction or send it back for refund
email toothbar@carverequipment.com
thanks
sc
OP
Anonymous Poster
Epic Contributor
- Joined
- Sep 27, 2005
- Messages
- 29,678
ForceTen
Bronze Member
Steve,
I need a toothbar for my NH 16LA HD bucket (72"). Are you familiar with this bucket, or do I need to send you the measurements? Also, are there any additional measurements that you need besides the inside width? And finally, I want to get two bolt on cutting edges for the sides of my bucket (to reinforce the bucket sides - they take a beating with the work I do). Would you be willing to take a shot at making those?
Steve
There are old pilots, and there are bold pilots, but there are very, very few old bold pilots. And they get scarcer every day.
I need a toothbar for my NH 16LA HD bucket (72"). Are you familiar with this bucket, or do I need to send you the measurements? Also, are there any additional measurements that you need besides the inside width? And finally, I want to get two bolt on cutting edges for the sides of my bucket (to reinforce the bucket sides - they take a beating with the work I do). Would you be willing to take a shot at making those?
Steve
There are old pilots, and there are bold pilots, but there are very, very few old bold pilots. And they get scarcer every day.
Here are some similar links:
