throttle stop

   / throttle stop #1  

kenmac

Super Member
Joined
Feb 13, 2005
Messages
9,830
Location
The Heart of Dixie
Tractor
McCormick CX105 Kubota MX 5100 HST, Kubota ZD1021, Kawsaki Mule 4010 trans 4x4
There is a throttle stop that hits against my injector pump when I push the throttle all the way open. Is there a corect setting for this (it is adjustible)? Is it ok to adjust it so that the throttle opens farther to give more fuel to the motor?
 
   / throttle stop #2  
The throttle on my 2210d is set to stop at 2600 rpms. I can't imagine have to run more rpms than that. I have found that 2100 to 2300 rpms is plenty for just about everything I have used it for. 2600 rpms seems to wind the motor pretty tight.
 
   / throttle stop #3  
Kenmac,

Originally, there was a small safety wire twisted from the jam nut and to the threaded rod. This safety wire indicated where the factory set and adjusted fuel pump amount and timing.

Often, I have adjusted the throttle rod and related hardware. I am not positive but I think that you can damage the pump by setting (adjusting) the throttle and it's timing. Maybe someone else is a little better qualified to set us straight.

Mark
 
   / throttle stop #4  
I can't imagine any reason to run a Yanmar over 2600 rpm.
 
   / throttle stop
  • Thread Starter
#5  
I found a post to my question.I guess this engine rpm also applies to 3110 engine speed
 

Tractor & Equipment Auctions

8 Ft Fork Extensions (A50322)
8 Ft Fork...
TAKEUCHI TL8R2 SKID STEER (A51242)
TAKEUCHI TL8R2...
Master MGH8500IE 8,500-Watt Generator - Electric Start, 18HP Honda Engine (A51039)
Master MGH8500IE...
2016 ROADTEC RP-190E ASPHALT PAVER (A51222)
2016 ROADTEC...
TANNKO  130BBL VAC TRAILER (A50854)
TANNKO 130BBL VAC...
PLEASE CHECK BACK!!! ITEMS BEING ADDED DAILY!!!! (A50775)
PLEASE CHECK...
 
Top