Simple tool for relieving hydraulic pressure

[i7win7]

Some grapples and front end implements are set up with one male and one female coupler. Don't have to think about what hose goes where I guess.

No dust covers needed on implements, connect hoses together.

 

[seville009]

problems on the implement side hoses while it’s off are usually due to temperature changes. i just push the female end againt a metal corner on the equipment somewhere. works well and i don’t have to remember where i left another tool.

 

[Peter 315]

problems on the implement side hoses while it’s off are usually due to temperature changes. i just push the female end againt a metal corner on the equipment somewhere. works well and i don’t have to remember where i left another tool.

That's how I do it but a use a rag to catch the oil...

 

[aaronrkelly]

I remember the first time I had to reattach my grapple and could not get the couplers on. Guys here gave good advice and kept me from looking like a dufus by calling the dealer.

Since then, on both the grapple and tree/post puller, I turn off the engine, turn the key back on and operate the third function button before unhooking the couplers. So far, so good.

But for $4 and a bit of grinder work, I think the OP idea is worth having in my kit. I will eventually screw up and have to beat on the couplers to relieve pressure.

I remember seeing a commercial tool that did the same thing but I was too cheap to buy it. I will make up a brass or aluminum piece in place of the wood plug, drill a hole in it, and attach it to the plier so I do not lose it.

Found the commercial tool:
The Waite Hydraulic Decompression Tool - BoltOnHooks LLC

I bought a few of those - they are AMAZING!