Old kubota B6100-d needs help

[Barney6595]

Kubota B6100 - Looking for the 2 rear axles used okay,
also 3 point hydrolics raise ok but won't hold and bleed of immediately. Is this a hard fix like the clutch was?

 

[5030]

Good luck on finding parts. You 'bleed off' is the rockshaft piston ring that is failed.

 

[Barney6595]

Good luck on finding parts. You 'bleed off' is the rockshaft piston ring that is failed.

Thank You, I'll look that up, I do have the old original owners manual.

 

[5030]

You'll need a shop manual for that I suspect. On the older Kubota units, the rockshaft casting and internal piston and linkage come off from the top of the gearcase. Not a big job but parts may be an issue.

 

[Barney6595]

thanks, I was looking at the diagram and wondering where the entry point was. Looks like there are a couple of o-rings and a seal in there. it would be nice to get rear hydrolics working. Right now I use the Manual method - ratch strap come-along to adjust hieght.