Loader boom cylinders uneven

[Ken P]

Folks - I was taking my loader (LA 352) off my B2410 today (to put on the snowblower) and noticed that the boom cylinders were uneven. That is, the clutch side boom cylinder was pushed out more than the left. It was very difficult to remove the loader, also - one side came off and the other didn't, until I horsed around with it quite a bit. Nothing leaking. No accidents or problems up until today.

Could anyone point me to how I go about diagnosing and (hopefully at home) repairing? Much appreciated -

Ken in North Granby, CT

 

[RayIN]

Sounds to me like the gland nut threads are stripped, then the hyd. oil got out of balance in the cylinder.

 

[TMGT]

The cylinders are self equalizing, the mounting brackets/loader assembly are what keep them even.

I assume this issue was before the loader was removed.

If so, its possible the mounting brackets have shifted, also possible the frame has been tweaked. Brackets would be my.first guess though.

You can reset them my parking on a hard flat surface (preferably flat concrete) and with the loader mounted and bucket grounded, lossen the mounting bracket bolts then re-torque them to specs.
You may have to move the bucket a little while the bolts are lose to shift things around.

Sent from my SM-S921U using TractorByNet mobile app

 

[RjCorazza]

In addition to what @TMGT states, it's possible to damage the crossover tube between the loader arms. Similar symptoms will result, and the damage is not always obvious.