Implements operate jerky

   / Implements operate jerky #1  

Wood Hound

New member
Joined
Jun 19, 2011
Messages
5
Location
Houston, TX
Tractor
Mahindra 3016
The rear implements on my rear top-n-tilt operate very jerky when changing position when moving in down direction. My restriction orifice doesn't seem to help. How does the orifice work and on which hydraulic line. Are there any other recommendations to smooth out the operation?
 
   / Implements operate jerky #2  
Restriction orifice needs to be in the line that control flow out of cylinder when lowering or moving via gravity especially if you have PO check in the circuit.
 
   / Implements operate jerky #3  
A couple of things. You will find that the whole system works better to have a flow restrictor at each port.
So you should have 4x .030 restrictors for your top & tilt set.

Second thing, try feathering the controls.
 

Tractor & Equipment Auctions

378811 (A51573)
378811 (A51573)
2015 Ford F-550 Ext. Cab Enclosed Service Truck with Liftgate (A53422)
2015 Ford F-550...
2013 Chevrolet Van (A55973)
2013 Chevrolet Van...
Hr:8,875 vin:316000649 (A53421)
Hr:8,875...
1999 Toro Reelmaster 5400-D 100in Fairway Reel Mower (A55851)
1999 Toro...
30pc 3ft. x 8ft. Red Polycarbonate panels (A53424)
30pc 3ft. x 8ft...
 
Top