Hose Supplier.

[psj12]

I need some Hydraulic hose to operate my new grapple. it needs to be 3/8 inch and a working pressure of 2,500 PSI. I would like to use screw on removable ends like Aeroquip. Does anyone know an inexpensive supplier of these items. Since I am running hose from the rear QDs I will need quite a bit of hose.

 

[kennyd]

DHH has both. But I suggest you use 1/4" hose, it willl be cheaper and is well suited for your grapple.


Where in MD are you-It may cheaper just to get two hoses made locally...

 

[psj12]

I am having the items shipped to OK where my tractor is. I am also looking for adapters from Chinese metric o ring face seal to pipe or JIC.

 

[wedge40]

I am having the items shipped to OK where my tractor is. I am also looking for adapters from Chinese metric o ring face seal to pipe or JIC.

Oh Oh, this could be a challenge.. I went through this last winter. Back then I couldn't find anybody that had the chinese face seal connectors. I ended up having my hose cut and JIC connectors installed.

Wedge

 

[Stimw]

I have a Chinese backhoe and needed a couple new hoses because the original hoses were crimped wrong, hoses not inserted fully. After a lot of messing around with metric and flat face fittings I just welded JIC to my old fitting end. I Ox/Act. welded these.