grapple hydraulic setup 1026r

   / grapple hydraulic setup 1026r #71  
There's something wrong with the color balance on your camera - these sure don't look orange in the pics :laughing:

What other color would he have? Even his chop saw is green :laughing:

Great looking grapple. :thumbsup:
 
   / grapple hydraulic setup 1026r
  • Thread Starter
#72  
ForumRunner_20120812_220135.png



ForumRunner_20120812_220204.png
 
   / grapple hydraulic setup 1026r
  • Thread Starter
#74  
Thanks. I'm heading to deere tomorrow to get the fittings I don't have. I decided to split the original loader lines and terminate the ends at the valve
 
   / grapple hydraulic setup 1026r
  • Thread Starter
#75  
The tractor is back and the tractor side hydraulic hoses are connected. I'm going to plumb the grapple cylinder to the quick connects for my new front work ports and hook up the electric switch tomorrow. Wish me luck! I'll take pics when it works and post an updated parts list.
 
   / grapple hydraulic setup 1026r #76  
Hello;

I'm kinda in the same boat as Swick1. A couple weeks ago a Wildkat 48" Econo Grapple was delivered to me. So now i'm in the getting hoses, couplers and routing stages.

Regarding hoses. I found that our local JD dealer was the cheapest per foot cost on the hoses. How much to attach ends I don't know. NAPA was considerbly more per foot

Thanks,, nicholas
 
   / grapple hydraulic setup 1026r
  • Thread Starter
#77  
I got the valve and hoses done. I used a footswitch to activate the valve and hooked into a spare switched connection provided by Jd for a lift solenoid kit that hasn't materialized. The switch is after the valve and connects to the ground connection on the engine.
 
   / grapple hydraulic setup 1026r
  • Thread Starter
#78  
Ok, the valve clicks but doesn't allow the fluid to escape the grapple ports even when I crack the fittings. Any ideas? I've already tried reversing the polarity. The valve is getting pressure.
 
   / grapple hydraulic setup 1026r #79  
You may have the solenoid on to tight.

Also don't over tighten the mounting bolts.

Some solenoid valves have a manual mode of operation.
 
   / grapple hydraulic setup 1026r #80  

Tractor & Equipment Auctions

2010 Chevrolet Tahoe SUV (A50324)
2010 Chevrolet...
2021 MDB TF150R 84" HYD MULCHING HEAD (A51243)
2021 MDB TF150R...
UNUSED AGT YSRT14 STAND ON SKID STEER (A51243)
UNUSED AGT YSRT14...
2018 Chevrolet Malibu (A50324)
2018 Chevrolet...
2006 FONTAINE TH55 SERIES 102" X 42' LOWBOY TRAILE (A51243)
2006 FONTAINE TH55...
2015 CATERPILLAR 305E2 CR EXCAVATOR (A51242)
2015 CATERPILLAR...
 
Top