OP
chrisdvorak
Gold Member
Yes it's closed, I have the air filter off of it right now.
bobcat 732 engine problem
- Thread starter chrisdvorak
- Start date
- Views: 29007
DJ54
Elite Member
- Joined
- Jan 20, 2009
- Messages
- 4,661
- Location
- Carroll, Ohio
- Tractor
- IH Farmall 656 gas/ IH 240 Utility/ 2, Super C Farmalls/ 2, Farmall A's/ Farmall BN/McCormick-Deering OS-6/McCormick-Deering O-4/ '36 Farmall F-12/ 480 Case hoe. '65 Ford 2000 3 cyl., 4 spd. w/3 spd Aux. Trans
Is it possible to place your palm over the throat of the carb for a few seconds while rolling over, to check for vacuum, & see if it will pull fuel that way..??
Spark advance port plugged..?? No tears, or tiny pieces of the body gasket missing around the tiny internal passages..?? The Holley on my Ford 3 cyl. had a tear in the body gasket, and was doubled over, leaving maybe a 1/8" air gap, where a PO had apparently had it apart before. Had to choke it forever to get it started, then would surge. Glued it back in place with some gasket sealer, and eliminated the problem.
Spark advance port plugged..?? No tears, or tiny pieces of the body gasket missing around the tiny internal passages..?? The Holley on my Ford 3 cyl. had a tear in the body gasket, and was doubled over, leaving maybe a 1/8" air gap, where a PO had apparently had it apart before. Had to choke it forever to get it started, then would surge. Glued it back in place with some gasket sealer, and eliminated the problem.
midhi
New member
did you ever find your problem. I think I am having the same issue
Kyjimblair
New member
- Joined
- Aug 30, 2021
- Messages
- 7
- Tractor
- 732 bobcat 231 Massey
I have a 732 with Ford 1.6 engine , cranks good but won’t start.
just wondering if you got it running and what you did.
just wondering if you got it running and what you did.
