I was looking over my 2210 to add a temp gauge and the only place I see a pickup point is where the temp light indication switch is. I would like to keep the light and I prefer not to add a tee in the radiator hose. Am I missing a place where I can add a temp probe? Thanks
Adding a temperature gauge to 2210
- Thread starter passgas55
- Start date
- Views: 3407
normde2001
Elite Member
- Joined
- Mar 10, 2002
- Messages
- 4,163
I haven't done it, but I believe they normally install a "T" where the existing temp sensor is and run both from that.
Inspector507
Super Member
A tee does not usually work too well on a temp gauge. The sensors for both will need to be down in the water and it's not going to be easy to do that with a tee.
Eddie
Platinum Member
Inspector507 said:
"T" would not work on mine. Neither sensor would see the true temperature. Has to be down in the water.
vongiese
Silver Member
- Joined
- Mar 29, 2002
- Messages
- 165
- Location
- NW Montana
- Tractor
- Yanmar 2210D, Sany SY35 Excavator, Kubota 4060LE,
yup - it's one or the other....I went with the guage.
Do a search and you 'll find the right part you'll need.
However - for the oil pressure - you can oput a tee in-line nad end up with both the dummy light AND a guage....
have fun
mike
Do a search and you 'll find the right part you'll need.
However - for the oil pressure - you can oput a tee in-line nad end up with both the dummy light AND a guage....
have fun
mike
