Working lights

stevejd990 · Nov 29, 2005

I have a JD 990 on which I want to add working lights on the ROPS for plowing snow. Above the rear axle on either side of the ROPS, there is a "T" shaped connector, female as I recall. Is this wired to the existing switch on the dash? Also, does anyone know what the description of that "T" shaped connector is so I gan go to NAPA, or????? and get the male end.

Thanks,

Steve

deere_x475guy · Nov 29, 2005

I'd also like to know what the designation of that connector is. For now I used two female spade terminals but would rather use the right connector.

Ray2210 · Nov 30, 2005

It sounds like the same connector as I have on the back of my 2210. If so it's the same as a mid 80's Toyota connector and can be found at wrecking yards on 82-85 Celica's and Supra's in quite a few locations. The license plate light at the back is the easiest one to get. It may also be possibhle to find it on other years and models of Toyota's and possibly other Japanese cars. If you post a pic I can tell you for sure.