will a CK20 run this

[laurencen]

Hi all, after destroying a set of blades on the farm king 5 foot mower I want a rough cut, here is one for sale locally, he is asking 500 dollars and says its a finish cut pull behind 2 blades, at 5 foot I assume its one spindle with two half blades underneath, my quetion is , is it worth 500 dollars and will a CK20 gear run it, I have a lot of rocks and uneven ground in the ditches and this may be a solution, I wanted a 4 foot but nothing around here for sale

Thanks

 

[kentrodngun]

Unit looks to be in good shape. Good brand name and reasonable price. You're correct about single spindle & two blades. You would normally keep the blades dull on a rotary mower as dull blades splinter saplings and the like thus preventing regrowth.

A five footer on a CK20 should be fine provided you're not chopping down waist high growth (if you are, then lift, cut, lower & re-cut). I wear a construction hard hat (actually a logger's hardhat, complete with ear muffs) because I also run into a lots of rocks on my property.

 

[KAB]

I have used a 5' shredder behind my ck20 hst before. First time the field was mowed in what appeared to be 5 - 10 years. Low range, take it easy. I even used it to knock down , by backing into, heavy brush (largest about 2" diameter)

Kurt

 

[Pete Lawrence]

Looks to be missing a few parts, a three point pin and the PTO connection. I wouldn't call that a finish mower, more a bush hog / rough cut type. If the missing parts are included I think it's near or slightly above the upper end of the price range for a well used mower.

 

[PAB_OH]

That's a rough cut mower not a "two blade finish mower". Rhino makes some pretty good stuff IMO (see my sig line). $500 seems reasonable but not without the other half of the PTO shaft.

 

[driver444]

I have a Mahindra 2015, which is pretty similar in size and weight to the CK20. I have run a 5 foot hog on my machine, with the same results as the above posts. (I had to knock the high stuff down before I could just run over it) But a word of caution... More than anything, a five footer is heavier, and hangs further off the back of the tractor, making the front end very light. I've found that it can reduce the handling, especially on hilly ground. Not a deal breaker, but be careful.

 

[wallace]

That is a rotary cutter (brush hog as some might call it) and a SE4 is a 48" cut.
It is also missing some brackets for the top link as stated.
The cutter has been discontinued but rhino is ver good about parts.
To answere your question yes your CK20 will run it.

 

[IslandTractor]

I agree there are parts of the 3pt hitch missing but it appears usable as is. Just attach the pins then hook up a chain to that dangle thingy and it should pull fine. You won't be able to lift the rear of the mower easily but many folks use these bush hogs without a solid top link anyway. On the other hand, there is no tractor side to the PTO shaft in the photo and you will need that.

 

[laurencen]

the guy has the top link part and the driveshaft end, not sure why he took it off, anyway if all goes well will have it here sunday

thanks for the info, will let you know how well it runs, did get a price on a 48 inch one new, 4 weeks delivery and 2200 dollars, price is not the main concern, I would prefer a new one but 4 weeks is too long to wait

 

[laurencen]

Rick, SE4 you say is 48 inch, maybe its what I wanted in the first place, the guy is saying its a 5 foot unit, if its 48 then bonus