WICKED Toothbar will Transform Your Bucket

[EverythingAttachments]

Here are some more Wicked good words from a great EA Customer!
Travis

 

[EverythingAttachments]

Here's a WICKED Toothbar vid I stumbled upon this morning! #EAcustomersROCK
Travis

 

[Bearsixty7]

Are you getting caught up on orders or did I just happened to order when a batch was being made and one wasn't spoken for since I received it in 1 week?

 

[EverythingAttachments]

Are you getting caught up on orders or did I just happened to order when a batch was being made and one wasn't spoken for since I received it in 1 week?

That's awesome news!

Yeah, the Wicked toothbar orders have been shipping amazingly fast. #ExpressLane
Travis

 

[Williy]

Do you really need all the bolts on lip of the bucket?

willy

 

[EverythingAttachments]

Do you really need all the bolts on lip of the bucket?

willy

I don't think they're necessary on 72" buckets or less, because of how strong the Hardox steel is, and considering how rigidly installed those wedge keepers are.

That's why I added this to the page, so guys will know..

NOTICE: For buckets larger than 72 inches, EA recommends the customer to install at least two of the included lower carriage bolts. This will greatly enhance the beneficial bucket strengthening aspect of our Wicked Toothbar.

Travis

 

[Williy]

Thanks Travis

willy

 

[Cycledude]

My LS tractor has a 72 inch bucket with holes already drilled for bolting on a replacement wear-bar , if I ordered a EveryThing Attachments Wicked Toothbar would it come with the holes already in it to match so I could just bolt it on with only having to drill the two outside edge bracket holes ? My tractor doesn’t even have 200 hours on it so there is very little wear on the factory wear-bar.

 

[Bearsixty7]

My LS tractor has a 72 inch bucket with holes already drilled for bolting on a replacement wear-bar , if I ordered a EveryThing Attachments Wicked Toothbar would it come with the holes already in it to match so I could just bolt it on with only having to drill the two outside edge bracket holes ? My tractor doesn’t even have 200 hours on it so there is very little wear on the factory wear-bar.

They do offer a complete bolt on option but it would not have the side brackets. They have a template to send you to fill out with all the measurements needed. If you get the standard one with side brackets, you have to drill your bucket to match the toothbar holes.

 

[PILOON]

I added a DIY tooth bar to my CUT and it thinks it is a skid steer now.
Must be over 7-8 years and no looking back.
Our soil breeds rocks and that bar sure helps.