danielk
New member
That's some beautiful land!Warn 12k, snatch block and yanked right out (well, twenty minutes).
View attachment 4080780
That's some beautiful land!Warn 12k, snatch block and yanked right out (well, twenty minutes).
View attachment 4080780
you're right. The difference is if the winch is mounted to the same vehicle being pulled. If the winch is mounted on a different vehicle than the one you are pulling, the fixed/anchored snatch block just changes the pull direction.Then it’s not being used correctly. The block attached to the load of course.
There are times that a redirect is required. And there are those time that a redirect of the cable through a snatch block does not increase the pulling power of the winch and the snatch block is being used properly for one of its designed purposes.Then it’s not being used correctly. The block attached to the load of course.
If the winch is mounted on the vehicle you want to move, the snatch block could be attached to a deadman location (such as a tree) the cable doubled back to the stuck vehicle or nearby anchor point. Thus would increase the winch’s pulling power, but the snatch block would not move as the vehicle movedThe 12K winch mounted on my tractor. BTW a snatch block doesn't change the pulling force unless the end of the winch cable is anchored and the snatch block moves with the load. If it is anchored to a tree it only changes the direction of the pull. Attachments
If the winch is mounted to the tractor, and the cable goes out to a pulley mounted on an immovable object, then back to the tractor, that's a 2:1 mechanical advantage.The 12K winch mounted on my tractor. BTW a snatch block doesn't change the pulling force unless the end of the winch cable is anchored and the snatch block moves with the load. If it is anchored to a tree it only changes the direction of the pull. Attachments
I don't think so.It’s simple to remember that the block must be in motion to double the pull minus friction of course.
I don't think so.There are times that a redirect is required. And there are those time that a redirect of the cable through a snatch block does not increase the pulling power of the winch and the snatch block is being used properly for one of its designed purposes.
If the winch is mounted on the vehicle you want to move, the snatch block could be attached to a deadman location (such as a tree) the cable doubled back to the stuck vehicle or nearby anchor point. Thus would increase the winch’s pulling power, but the snatch block would not move as the vehicle moved
There are many ways to use a snatch block, some will increase the pulling power of the winch and others will not.
Redirects are a proper usage design of a snatch block as is the usage to increase pulling power.
Finally -- an explanation that is almost correct.I don't think so.
- Winch mounted on a tractor, cable out to an immovable object is 1X mechanical advantage, or full pull.
- Winch mounted on a tractor, cable out to a snatch block that is fixed to an immovable object than back to the tractor is 2X mechanical advantage... twice the pulling power but half the speed.
The block does not move.
This is true. There are all sorts of sites that show how to use snatch blocks as well as plenty of YouTube videos. Folks just need to look and learn.I can hardly wait until somebody brings up using two snatch blocks. Or three.
The amount of confusion about using just a single one is amazing.
Or just stop and think. After all, it's only very basic physics.This is true. There are all sorts of sites that show how to use snatch blocks as well as plenty of YouTube videos. Folks just need to look and learn.
Eric
You are correct about the amount of cable/rope on the drum as per the strength.I started with Jeeps in 1965 when I was 17. My Jeep featured in Four Wheeler magazine in 1966. You forgot about the amount of cable on the drum effect. Most winches are rated with a minimum wrap.
We had lots of stuck trucks with the utility company drivers. Ten wheel drive trucks with big winches (hydraulic drive no voltage and amperage concerns) were the rescue vehicles. I still have a rope block in my shop mezzanine triple pull. Don’t ever use it as my 36’ Gradall handler has a decent winch.
You mean like this?I can hardly wait until somebody brings up using two snatch blocks. Or three.
The amount of confusion about using just a single one is amazing.