Rounded off drain plug

[MossRoad]

Maybe if he sharpened his chain it would cut better.

 

[MossRoad]

And since I set 50 posts per page in "Settings" the thread is 42 pages on my computer:
View attachment 728098

Me too.

 

[ljjhouser]

I think you have a size problem.
I'm only on page 21 as of this post.
I like big pages.

I can't stop chuckling. I checked with my wife. There is no size problem. .............. HA HA - I am set at the default. You must be seeing at about 100 posts per page. Wonder if I will live long enough to see this thread end? Ha. It is amusing.
Yesterday at 8:52 PM

• Add bookmark

#2,075

Rounded off drain plug​

• Thread starterKando
• Start dateMar 30, 2018

Prev

• 1
• …
• 206
• 207
• 208
• 209

Next

 

[DieselBound]

I wonder whether he ever tried getting that thing out with a... pallet!

NOTE: heating and cooling is still a good approach; if not a torch then perhaps a heat gun set on stun...

 

[Fuddy1952]

Once again...I should know better by now. Drinking a soda reading replies like this!!!!!

 

[jaxs]

I wonder whether he ever tried getting that thing out with a... pallet!

NOTE: heating and cooling is still a good approach; if not a torch then perhaps a heat gun set on stun...

Saaay there,i don't believe he did. I also don't recall anyone suggesting he try it with his fingers either.

 

[Kando]

Oh good lord.

Hello!

Can't remember if I actually stated, issue with using a pipe wrench was that it just sheared material from the plug.

The beam running underneath is a support between the loader frame, bit of a hassle to remove and replace (due to pressure on it) but ended up doing so to drill through the plug and use the easy out bit shown in the plug back in whichever post I uploaded that picture in.

 

[gstrom99]

Wow. Three+ years and 209 pages, for such a (fairly) simple/common problem.

 

[airbiscuit]

 

[Jstpssng]

Oh good lord.

Hello!

Can't remember if I actually stated, issue with using a pipe wrench was that it just sheared material from the plug.

The beam running underneath is a support between the loader frame, bit of a hassle to remove and replace (due to pressure on it) but ended up doing so to drill through the plug and use the easy out bit shown in the plug back in whichever post I uploaded that picture in.

Yes, you mentioned it in post # 10. (The only reason I know that is because in the latest resuscitation of the thread, it was mentioned a few days ago.)