mlong75107
New member
I have an older B7100D and need to replace the gear shift boot. I have acquired the boot, but cannot get the gear shift knob off. There is a hole in the middle, if that helps. Any ideas?
Remove Gear Shift Knob
- Thread starter mlong75107
- Start date
- Views: 9688
Wagtail
Super Star Member
- Joined
- Jan 15, 2013
- Messages
- 12,982
- Location
- St Helens, Tasmania, Australia
- Tractor
- JD 4105 / JD Z355E (48" deck)
G'day Mate and welcome to TBN from Downunder.
Gear Shift Knob removal has come up recently in other threads. The consensus seems to be that the knobs are on there permanently and need to be cut off.
Have a look at the bottom of this page in "Similar Threads"... your answer may lay there.
Gear Shift Knob removal has come up recently in other threads. The consensus seems to be that the knobs are on there permanently and need to be cut off.
Have a look at the bottom of this page in "Similar Threads"... your answer may lay there.
PILOON
Super Star Member
Mine are plastic and I believe simply pressed on. Heat would soften the plastic and you should be able to then pry the knob off.
I re-installed my knob by stuffing with hot glue and pushing into place.
I re-installed my knob by stuffing with hot glue and pushing into place.
longshot47
Bronze Member
- Joined
- Sep 1, 2009
- Messages
- 77
Heat gun.
Fix something like a pair of vise-grips below the knob, and pry off after careful heating. Heat again, reapply, tap in place
Worked pretty well on my 7610.
Fix something like a pair of vise-grips below the knob, and pry off after careful heating. Heat again, reapply, tap in place
Worked pretty well on my 7610.
