Rebuilding Ford 4000 engine

   / Rebuilding Ford 4000 engine #1  

Jbrandon

New member
Joined
Feb 8, 2019
Messages
9
Location
Southeast Alabama
Tractor
Massey ferguson 35 deluxe, Ford 4000
I am in the process of rebuilding the engine in my 1970 ford 4000 3cyl diesel. It had a broken crankshaft. I put everything new in but the rods and the piston height above block was .028 to .038. I figured the rods might be stretched because of the broke crankshaft so i installed new rods and now piston height is .022 to .028 above block. Is the height okay for a .056 head gasket?
 
   / Rebuilding Ford 4000 engine #2  
I would have to look it up, but I believe that is right. The thicker gasket would be correct. The rods would not stretch though.
 
   / Rebuilding Ford 4000 engine
  • Thread Starter
#3  
Thanks for the reply Tractor Tech. A mechanic mentioned that the rods could have stretched and i didn't know what else to try
 
   / Rebuilding Ford 4000 engine #4  
I would probably stay away from that mechanic...
 
   / Rebuilding Ford 4000 engine #6  
Haha, yeah, stay away from this "mechanic". But if you do see him again, ask him how the rods stretch. I think we all want to hear this.
 
   / Rebuilding Ford 4000 engine
  • Thread Starter
#7  
I know he has rebuilt a lot of gas engines. He mentioned it after i told him the crankshaft was broken and it did lower each piston about .008 but i don't know if that is enough. Thanks for all the comments
 

Tractor & Equipment Auctions

Chapin 25 Gallon ATV Sprayer (A54865)
Chapin 25 Gallon...
Dell Latitude 5500 Laptop (A53425)
Dell Latitude 5500...
2015 Ford E-350 Cutaway Van (A55973)
2015 Ford E-350...
2012 CHANDLER 130 BBL STEEL VACUUM TRAILER (A53843)
2012 CHANDLER 130...
KENWORTH ROLLBACK TOW TRUCK (A52706)
KENWORTH ROLLBACK...
2020 INTERNATIONAL MV607 24FT NON CDL BOX TRUCK (A56129)
2020 INTERNATIONAL...
 
Top