Rear remote studs- Where to find?

[WranglerX]

Maybe here...... Bell Metric... If you want metric bolts, nuts, washers, etc: go to a metric supplier.....

Metric Fasteners & Hardware｜BelMetric

Bel-Metric sells metric hardware & specialty automotive supplies worldwide. Visit our website to purchase metric fasteners, nuts, bolts, screws, washers & more.

belmetric.com

More specific....

M10 Full Thread Stud DIN 976, Class 8.8 Steel

Bel-Metric sells metric hardware & specialty automotive supplies worldwide. Visit our website to purchase metric fasteners, nuts, bolts, screws, washers & more.

belmetric.com

 

[OldTrix]

wrong thread- I need M10-1.25, not 1.5

 

[WranglerX]

Well instead of "stud" try threaded rod....

M10 x 1.25 Steel Threaded Rod select 85mm to 500mm | eBay

M10 x 1.25 steel thread rod. 8.8 Grade. You can select the length you need. "Buy it now".

www.ebay.com

McMaster-Carr

McMaster-Carr is the complete source for your plant with over 595,000 products. 98% of products ordered ship from stock and deliver same or next day.

www.mcmaster.com

 

[Shenandoah MF1760]

I'm adding a second rear remote to my Mahindra 2665, and I will need longer studs to accommodate the two valves. It's an M10-1.25 stud, and I'm looking for a 195-200mm stud to fit. So far, McMaster, Graingers, Fastener mart have all been fails. Does anyone know a source for long metric studs?

Not a stud, but this may be a source for the future if you're not happy with what you've found.

 

[OldTrix]

yeah, I found plenty of Ti bolts, for around $30/ea... nope.

I have a set of chinesium bolts as well as the set from hammerhead enroute. Will just have to remove the toolbox to set everything in place with the greater height/length of bolts.

 

[Shenandoah MF1760]

yeah, I found plenty of Ti bolts, for around $30/ea... nope.

I have a set of chinesium bolts as well as the set from hammerhead enroute. Will just have to remove the toolbox to set everything in place with the greater height/length of bolts.

I found a number of Chinese sources, but I'm loath to send anyone to them. I have worked for a Chinese company and they'll try to get away with anything they can. This is freely admitted to by the Chinese nationals I've worked with. I wouldn't trust a grade 8 bolt of theirs to be anywhere close to grade.

 

[OldTrix]

agreed, I also avoid them for the same reasons. Most of it is crap.