Pulling a ratchet rake tooth....

[Buckgnarly]

Double bevel, but I should have taken it a little easier on the top. It's probably off by about 1/8 up, not a big deal just careless on my part!

 

[kyles974]

And then there are those of us who will just have to wait for the little one to go on sale...

Nice work!!!

:thumbsup::thumbsup::thumbsup:

Don't wait!
I bought one.....and I think after using it for thirty minutes, it paid for itself from the wear and tear I already kit on my tractor NOT using one!

 

[madmax12]

Don't wait!
I bought one.....and I think after using it for thirty minutes, it paid for itself from the wear and tear I already kit on my tractor NOT using one!

I believe u... R u going to post any pics of your cool tool and the work u did? What project did u use yours for?

 

[sparc]

Don't wait!
I bought one.....and I think after using it for thirty minutes, it paid for itself from the wear and tear I already kit on my tractor NOT using one!

Buy the 72" if you can find one and cut it down to the width you need. It will cost less even if you have to pay some one to weld it up for you.