Power Beyond - a short course

[BukitCase]

I subscribed to this newsletter about a year ago - not always applicable to tractors, but I've gotten several good tips so far. This was today's, and it covers a few things I didn't know. Thought I'd post a link here, and if you're interested you can sign up for the free email newsletter at the bottom of the page...

Hydraulic valve power beyond or high pressure carry over

They also wanna sell you the complete book, but it's just a link in emails every so often. Your choice to ignore.

Merry Christmas everyone... Steve

 

[J_J]

I get the news letterl from those guys all the time.

I wished I had the software he uses for demos.

You set up a hyd circuit and can see the results.

 

[BukitCase]

Yeah, me too - but knowing how "proud" companies are of their custom software, if I actually had the money to spare I'd most likely be fondling my new PlasmaCam table for my Hypertherm 45 first (til then, I'll eventually be building my "radial plaz" thing I mentioned in Jim Gherkin's air compressor thread in the welding forum... Steve

http://www.tractorbynet.com/forums/welding/294946-i-am-looking-air-compressor-11.html

 

[J_J]

I will be hooking up my plasma cutting table soon with my PRO-CUT-55.

 

[BukitCase]

OK, I'm officially jealous (happens a lot :laughing: )

Soooo, which table, which software, and why? (Enquiring minds/tool sluts wanna know) Steve

 

[J_J]

I have had this table for a while, but no where to set it up. It is a Practical CNC table. Cant remember the software, but might be Bobcad.

It is a 4x4 ft, convertible to a 4 x 8 ft table. The reason for the 4 ft was for taking it on the road using a covered trailer and generator for flea mkts and shows. Weather vanes, silhouettes, small cut outs,etc.

I also have plans for something like this. CNC router

https://www.youtube.com/watch?v=-wloUF6ZaQ4

https://www.youtube.com/watch?v=_Z88VW5Jab4