o6 gmc canyon engine knocking

   / o6 gmc canyon engine knocking #1  

echoman

Member
Joined
Jun 19, 2011
Messages
36
Location
wv
Tractor
kubota b2920
My wifes canyon with a inline 5cyl engine with 116000 miles ,has a knocking sound at the front of the moter.Its only at idle as soon as you start to rev it up it goes away.If it was a v8 I would say its a timing chain,but Iam no sure if it has timing chain or a belt.Any suggestions would be helpful thanks
 
   / o6 gmc canyon engine knocking #2  
Not sure but my mechanic has replaced two of these motors in the last 4 month. One on the truck and one on a SUV. Weird setup with the front drive shaft going through the oil pan.

Chris
 
   / o6 gmc canyon engine knocking #3  
any difference with different fuel grades?

soundguy
 
   / o6 gmc canyon engine knocking
  • Thread Starter
#4  
Soundguy,not a fuel pinging noise. thanks
 
   / o6 gmc canyon engine knocking #5  
any difference with different fuel grades?

soundguy

I am thinking along the lines of detonation or valve train noise. A rod knock would continue thru the rpm band. The lifter in this motor, I am assuming, are hydraulic, maybe one is not "primed" enough at idle but pick ups lube as acceleration is applied.
 
   / o6 gmc canyon engine knocking #6  
Does this have a timing belt inside a cover? When slack, those have the exact symptoms you describe. So the problem could either be the belt or the tensioner (assuming the vehicle has a timing belt, that is).
 
   / o6 gmc canyon engine knocking #7  
s219 said:
Does this have a timing belt inside a cover? When slack, those have the exact symptoms you describe. So the problem could either be the belt or the tensioner (assuming the vehicle has a timing belt, that is).

It is a chain, not a belt.
 
   / o6 gmc canyon engine knocking #8  
Check idler pulley on serpentine belt.
I bought a Chevy Van CHEAP that sounded like a rod knock and I found the pulley bad.
 
   / o6 gmc canyon engine knocking #9  
Check idler pulley on serpentine belt.
I bought a Chevy Van CHEAP that sounded like a rod knock and I found the pulley bad.

That'd be my first check too..They tend to quiet down when the RPM's come up.

Easy, cheap fix.
 
   / o6 gmc canyon engine knocking
  • Thread Starter
#10  
Thanks for all of the repliys I would have bet a $100 that it was a timing chain,but I would have lost.water pump ,fan clutch,and while it was in the shop,new idler pulleyand belt.$600and change.
 

Tractor & Equipment Auctions

2016 Ford Explorer AWD SUV (A51694)
2016 Ford Explorer...
UNUSED JCT 84" HYD DOZER BLADE (A51248)
UNUSED JCT 84" HYD...
2013 Audi Q7 AWD SUV (A51694)
2013 Audi Q7 AWD...
UNUSED WOLVERINE TCR-12-48H 48" HYD TRENCHER (A51248)
UNUSED WOLVERINE...
2021 John Deere 310SL Backhoe (A53342)
2021 John Deere...
2020 JOHN DEERE 7R210 LOT IDENTIFIER 49 (A53084)
2020 JOHN DEERE...
 
Top