Opti-Mist
Platinum Member
I had one, did a nice job, even on blind rivets (on an aluminum boat).
Need rivet gun recommendations
- Thread starter coloradotrout
- Start date
- Views: 3453
OP
coloradotrout
Gold Member
- Joined
- Aug 19, 2005
- Messages
- 342
- Location
- Eastern KS
- Tractor
- JD 4100 HST CUT w/Yanmar 3TNE74 | JD 300 Lawn
I couldn't justify buying a new toy 
stsid1
Bronze Member
- Joined
- Sep 13, 2018
- Messages
- 68
- Tractor
- Yanmar YM2000, John Deere 3020, and a few others
Hand model is easier to use, no compressor to drag out, no drop cords and no hose. Air maybe faster but the time you drag all that out to use it then store it. Then if you are where working near no power, then you got to get the generator out.
Smokeydog
Elite Member
The usual mechanical pop rivet guns are good for common aluminum rivets.
I use a small hand Huck hydraulic for SS, steel and large aluminum/steel mandrel pop rivets. Also have same that uses air over hydraulic. Surplus aircraft manufacturing eBay finds.
I use a small hand Huck hydraulic for SS, steel and large aluminum/steel mandrel pop rivets. Also have same that uses air over hydraulic. Surplus aircraft manufacturing eBay finds.
metalbender
Veteran Member
When I built my ice fishing shack, I used a lot of rivets. The stainless ones were a tad tough for a hand unit. Purchased an air powered one from Princess Auto. Great investment.
Fuddy1952
Elite Member
- Joined
- Apr 17, 2018
- Messages
- 3,191
- Location
- South Central Virginia
- Tractor
- 1973 Economy and 2018 John Deere 3038E
These I've had good luck with, and what gutter installers just used on the horse stable.
OP
coloradotrout
Gold Member
- Joined
- Aug 19, 2005
- Messages
- 342
- Location
- Eastern KS
- Tractor
- JD 4100 HST CUT w/Yanmar 3TNE74 | JD 300 Lawn
Yes. Plan to use those and rivet the 10' sections together. Too cheap to go seamless on the pole barn made of reclaimed everything!
Fuddy1952
Elite Member
- Joined
- Apr 17, 2018
- Messages
- 3,191
- Location
- South Central Virginia
- Tractor
- 1973 Economy and 2018 John Deere 3038E
I'm cheap too. I use a manual pop rivet tool.
Aussiebushman
Gold Member
- Joined
- Jul 31, 2008
- Messages
- 252
- Tractor
- Ford 6000
The drill powered unit I purchased has been useless. Also, I have given up trying to work with the short-handled units. By far the best are the log-handled riveters.
They come with either 2 or 3 collets and they all jam sooner or later, so you will find the 2-collet version much easier to reassemble because these drop nicely unto place, whereas the 3 collet models invariably don't and it may take several attempts to get to align correctly
Any reputable brand will do
They come with either 2 or 3 collets and they all jam sooner or later, so you will find the 2-collet version much easier to reassemble because these drop nicely unto place, whereas the 3 collet models invariably don't and it may take several attempts to get to align correctly
Any reputable brand will do
