need help

/ need help #1  

colorblind

New member
Joined
Jun 3, 2006
Messages
19
Location
billings missouri
Tractor
kioti ck30/with loader
I just had a limb wedge up against my foot throttl bracket. it caused my cable to open the throttle. The tractor just shut off immediately. I repaired the bracket and the throttle cable is in the idle position but I can't get the tractor to start. It is turning over just fine it just won't start. I have plenty of fuel in the tank. any thoughts would be greatly appreciated /forums/images/graemlins/confused.gif
 
/ need help
  • Thread Starter
#2  
I just had a limb wedge up against my foot throttl bracket. it caused my cable to open the throttle. The tractor just shut off immediately. I repaired the bracket and the throttle cable is in the idle position but I can't get the tractor to start. It is turning over just fine it just won't start. I have plenty of fuel in the tank. any thoughts would be greatly appreciated /forums/images/graemlins/confused.gif
 
/ need help #3  
Hello Colorblind, Where did this limb hit your tractor, from underneath or on top of the floor board? Matt
 
/ need help #4  
Hello Colorblind, Where did this limb hit your tractor, from underneath or on top of the floor board? Matt
 
/ need help #5  
Are you talking about the HST pedal? ...i thought you said that you bought the HST....could be wrong.
 
/ need help #6  
Are you talking about the HST pedal? ...i thought you said that you bought the HST....could be wrong.
 
/ need help #7  
Check that the fuel cutoff solenoid is working and that the manual fuel cut off cable did not get pulled somehow.
 
/ need help #8  
Check that the fuel cutoff solenoid is working and that the manual fuel cut off cable did not get pulled somehow.
 
/ need help
  • Thread Starter
#9  
It is the manual transmission. The limb hit underneath. There is a small bracket that the throttle cable attaches to that bent just enough to extend the cable some. I bent the bracket back where it is suppose to be at and both throttle cables are fine and in the idle position. I am not sure that I didn't get some bad diesel fuel I had filled up about 20 minutes prior to the incident. thanks /forums/images/graemlins/confused.gif
 
/ need help
  • Thread Starter
#10  
It is the manual transmission. The limb hit underneath. There is a small bracket that the throttle cable attaches to that bent just enough to extend the cable some. I bent the bracket back where it is suppose to be at and both throttle cables are fine and in the idle position. I am not sure that I didn't get some bad diesel fuel I had filled up about 20 minutes prior to the incident. thanks /forums/images/graemlins/confused.gif
 
/ need help #11  
Also check to see if the cable on the "kill pull" got pulled on. That's the red knob below where the key goes for cutting off the fuel solenoid for an emergency cut off. If that got bent, it could be keeping the tractor from starting.
John
 
/ need help #12  
Also check to see if the cable on the "kill pull" got pulled on. That's the red knob below where the key goes for cutting off the fuel solenoid for an emergency cut off. If that got bent, it could be keeping the tractor from starting.
John
 

Marketplace Items

UNUSED WOLVERINE MAD-12-12D 12" MINI HYD AUGER (A62131)
UNUSED WOLVERINE...
2014 Ford F-550 Altec AT40M 40ft Material Handling Bucket Truck (A61568)
2014 Ford F-550...
2016 Jeep Compass 4X4 SUV (A56859)
2016 Jeep Compass...
2019 International WorkStar 7300 4x4 Altec AA55 56ft. Insulated Bucket Truck (A60460)
2019 International...
378908 (A61166)
378908 (A61166)
2020 International LT625 Sleeper 48" (A62613)
2020 International...
 
Top