Oil & Fuel need advice

   / need advice #12  
Did they clean the strainer too? Would've been a great time to do that with a new spin on filter. Just saying. I doubt it hurt anything either.
 
   / need advice #13  
I would say the hydraulic pump is the first thing that gets hit in such a situation. I wouldn't be worried about any other parts.
 
   / need advice #14  
I think the lubricated parts probably had enough oil stuck to them to prevent any significant damage.
Did you get a transmission low fluid light, warning, or buzzer?

Did anything feel overly hot? Any burning smell? (Not my wifes cooking, your tractor) :laughing:
 
   / need advice
  • Thread Starter
#15  
have barley used the tractor, the plug coming completely out after a few hours on it was a factory issue, not my fault and yes they replaced screen and filter. hydraulic pump was my worry too but no low oil lights just a slight burning smell
 
   / need advice #16  
The question is why, who and where was the plug left unsecure. Just saying.
 
   / need advice #17  
Apparently no one knows why and it was by someone in the chain that built or sold it at some factory or dealer location. You know, incompetence is everywhere.
 

Tractor & Equipment Auctions

(APPROX. 20) 4' X 8' X 3/8" SHEETING (A52706)
(APPROX. 20) 4' X...
2017 Ram 4500 Bucket Truck (A55302)
2017 Ram 4500...
UNUSED WOLVERINE MAD-12-12D HYD AUGER DRIVE & BIT (A57193)
UNUSED WOLVERINE...
CRATOS SHERPA 100 ECO ELECTRIC STAND ON SKID STEER (A57192)
CRATOS SHERPA 100...
2014 Ford Taurus AWD Sedan (A55853)
2014 Ford Taurus...
2007 Sterling Acterra Dump Truck (A51691)
2007 Sterling...
 
Top