If the side link had float it would be nice to use while blowing snow.
My NX6010
- Thread starter MinnesotaEric
- Start date
- Views: 470690
If the side link had float it would be nice to use while blowing snow.
If the side link had float it would be nice to use while blowing snow.
OP
MinnesotaEric
Super Member
That is exactly what I thought I'd do is ditch the side link hydro and go with the factory link.
Deflector wise, I get serious wind off of my lake and so I'm thinking (but don't know until I do it) that being able to aim the shoot with the deflector may be a good thing.
aczlan, thank you for the Loftness tip! Loftness, along with Lorenz, and Provenost was in the group of blowers I was considering before stumbling upon this used blower.
Once I get the SnoLander fitted to my tractor and up and running, Murphy's Law suggests that it shall never snow again.
But if there is no snow, we can still go ice fishing.
OP
MinnesotaEric
Super Member
No float out back unless I screw in a non-factory valve body into the manifold.
countrybumpkin
Elite Member
- Joined
- Jun 14, 2005
- Messages
- 3,237
- Tractor
- Kioti, kubota
When things slow down this winter I'm planning on trying to look into a float setup for at least one rear valve.
comancheflight
Gold Member
Blow snow, I'm taking up ice fishing..
Threepoint
Veteran Member
- Joined
- Feb 13, 2014
- Messages
- 2,233
- Location
- No. VA
- Tractor
- Kubota B2150HST w/ LA350 loader, Kubota GF1800 HST, Kioti CK3510SE HST w/ KL4030 loader, Kioti NX4510HST/cab w/ KL6010 loader
Not just Murphy's Law, at least for this coming winter! NOAA: Strong El Niño sets the stage for 2015-2016 winter weather
OP
MinnesotaEric
Super Member
I got the McKee 720 Snolander moved and unloaded. Fitting it to my tractor must take a backseat for another couple of weeks as I'm still moving heading toward closing on the 12th and I have a project over at the new parcel that I must get my tractor over to complete before the ground freezes before I bring the tractor back again to the lake house to fit this McKee snow blower.
Last edited:
Xfaxman
Super Star Member
- Joined
- Feb 8, 2013
- Messages
- 12,885
- Location
- Guthrie, OK
- Tractor
- Toolcat 5610 G - Bobcat V417 - TORO+Loader
Congratulations on doing it the hard way. 
Next time raise it up and drive the truck forward, pulling the trailer out from under it. :thumbsup:
Next time raise it up and drive the truck forward, pulling the trailer out from under it. :thumbsup:
murphy1244
Super Star Member
- Joined
- Nov 25, 2011
- Messages
- 16,326
- Location
- Ohio
- Tractor
- Kubota 1120 RTV Kioti DK-40, MF-135, Ventrac 4500Y
Congratulations on doing it the hard way.
Next time raise it up and drive the truck forward, pulling the trailer out from under it. :thumbsup:
Then we couldn't hear the whole song.