Trail builder
New member
- Joined
- May 25, 2021
- Messages
- 1
- Tractor
- 2010 Kubota BX 25
I am trying to find a coupler to connect a hydraulic pump to the mid PTO on my BX 25.
Mid PTO coupler
- Thread starter Trail builder
- Start date
- Views: 910
BravoXray
Elite Member
- Joined
- Dec 17, 2019
- Messages
- 3,553
- Location
- Nothern Indiana
- Tractor
- Kubota BX2230, John Deere 430 Diesel
If you get the diameter of the shaft and the spline count, you should be able to get one from a farm supply dealer, like TSC or Rural King. If not, try your local Kubota dealer.
- Joined
- Dec 31, 2011
- Messages
- 12,583
- Location
- America's Dairyland
- Tractor
- Bobcat Toolcat 5610G, Deere X744, Cub Cadet IH 982
Like this adapter that gets to 1 3/8 6 spline?
E-PA13 PTO Adapter, 31/32" & 10 Spline Female, 1-3/8" & 6 Spline Male, 100HP | eBay
E-PA13 PTO Adapter, 31/32" & 10 Spline Female, 1-3/8" & 6 Spline Male, 100HP | eBay
- Joined
- Dec 31, 2011
- Messages
- 12,583
- Location
- America's Dairyland
- Tractor
- Bobcat Toolcat 5610G, Deere X744, Cub Cadet IH 982
I have a number of these shafts from a few implements (mostly front mowers and snowblowers and brooms). They are all different brands and models, too. JD, Ford/New Holland, etc. Some Some are spline to spline and others are spline to 1" round shaft, either drilled for a shear bolt or a keyway deal.
I have found a few from U-Pullit type junkyards, and some from auctions where they have a mid or front mower only, and even from Craigslist and FB marketplace.
Just count the splines. 15 as I recall on my F-935 mower and 1070 tractor.
You won't believe what they cost new. Cheapest one I've seen (New Holland cm274) is about $700 and the Deere is over $1000. so, buying a rusty mower deck with a drive shaft for $50 is a darn good deal. Air compressor attachment is also a nice occasional use for a mid-pto. Tank or no tank works effectively. Don't forget the safety-blow off valve !
I have found a few from U-Pullit type junkyards, and some from auctions where they have a mid or front mower only, and even from Craigslist and FB marketplace.
Just count the splines. 15 as I recall on my F-935 mower and 1070 tractor.
You won't believe what they cost new. Cheapest one I've seen (New Holland cm274) is about $700 and the Deere is over $1000. so, buying a rusty mower deck with a drive shaft for $50 is a darn good deal. Air compressor attachment is also a nice occasional use for a mid-pto. Tank or no tank works effectively. Don't forget the safety-blow off valve !
dstig1
Super Member
- Joined
- Apr 7, 2010
- Messages
- 5,663
- Location
- W Wisc
- Tractor
- Kubota L5240 HSTC, JD X738 Mower, (Kubota L3130 HST - sold)
Sweepster Rotary Broom - rebuild and modification
I'm going to start this thread a bit ahead of time so I can actually get input along the way rather than just showing finished pics as there are some areas I am less certain of. I have started taking apart bits of it but probably won't get seriously into it until Spring/early summer when it...
www.tractorbynet.com
