Adapting JIC from 3/8” to 1/2”?

[threepiece]

This project has turned out to be more complicated than expected and I’m barely halfway through.

I simply want to connect a control valve to the quick couplers. The control valve has six 3/8” male JIC ports with 9/16”-18 thread. The six quick couplers have 3/4”-16 male JIC threads.

So simply put, I want to connect a steel line to a device with a 3/8” male JIC on one end and a device with a 1/2” male JIC on the other.

It seems like a simple process but I can’t find a way with either 1/2” or 3/8” steel lines. Is this possible.

 

[Alan W.]

Did you check Surplus Center

JIC to JIC | Hydraulic Adapters & Fittings | Hydraulics | www.surpluscenter.com

JIC to JIC,JIC Male to JIC Male - Straight Union,JIC Female to JIC Male - Straight,JIC Male - Tee,JIC Female Swivel to JIC Male - Right Angle,JIC Male

www.surpluscenter.com

 

[threepiece]

Did you check Surplus Center

JIC to JIC | Hydraulic Adapters & Fittings | Hydraulics | www.surpluscenter.com

JIC to JIC,JIC Male to JIC Male - Straight Union,JIC Female to JIC Male - Straight,JIC Male - Tee,JIC Female Swivel to JIC Male - Right Angle,JIC Male

www.surpluscenter.com

I did thanks to you! I checked three other suppliers who did not have this. I began to think it was not available. Thanks a bunch!

 

[Alan W.]

I have ordered from them for years. I really like their hydraulic hoses.

 

[kennyd]

The valve has adapters screwed into the ports, they are most likely ORB/SAE ports. So, just get different adapters.