Least Tippy Machine

   / Least Tippy Machine #11  
you might look at orchard tractors. they are closer to the ground and may be a little wider
My career was 37 years in the California wine industry.

Orchard and Vineyard tractors are low and narrow. Have very high volume hydraulic systems for operating high volume sprayers. Some available on tracks.

In California all spray rigs must have cabs with positive air pressure inside to keep chemicals outside the cab.

Up until 2005, when I retired, none were designed for front end loaders.

These are low volume, specialized machines, unfortunately priced very high.
 
Last edited:
   / Least Tippy Machine #12  
I'd start filling them in or doze them rather than change a machine trying to find something more stable.


For fourteen acres having a bulldozer fill the holes may be the cheapest option.

Depending..................
 
   / Least Tippy Machine
  • Thread Starter
#13  
I think you all may have a good point with just getting the holes filled/pushed over with a dozer. I was planning on filling them with the tractor, but I don't feel comfortable running across all of the terrain with the tractor.

To answer the question: I'm sure it's operator-error. The tractor could probably be pushed much harder, but just because it can be done doesn't mean I have any interest in doing so.

It was just so odd in the T650; everything felt completely normal and I could roll around the property without caring what was in front of me. But when I get in the tractor, I'm in super slow-mo and watching every inch of the ground ahead. And then turn around anyway.
 
   / Least Tippy Machine #14  
I think you all may have a good point with just getting the holes filled/pushed over with a dozer. I was planning on filling them with the tractor, but I don't feel comfortable running across all of the terrain with the tractor.

To answer the question: I'm sure it's operator-error. The tractor could probably be pushed much harder, but just because it can be done doesn't mean I have any interest in doing so.

It was just so odd in the T650; everything felt completely normal and I could roll around the property without caring what was in front of me. But when I get in the tractor, I'm in super slow-mo and watching every inch of the ground ahead. And then turn around anyway.
And the reason for that is in the T650 you are "enclosed" you have "walls" around you and you feel safe. On the tractor you sit higher and the fenders stop well below your line of sight. You feel vulnerable and unsafe.

How does one raise their "tippyness" threshold? Over time you become less fearful. And for some people even to the point they become reckless. But you are not there yet. Not by a long shot. Have an experienced operator come in and operate your machine over every part of your terrain. It would likely make you feel a bit better if he says "nothing scary around here". That is all I can suggest. Don't trade your machine off. Trade off your fear.
 
   / Least Tippy Machine #15  
R4 tires are also wider than R1s. And they have stiff sidewalls and square shoulder tread, both of which will help reduce the likelyhood of a rollover. Their traction in mud or loose soil is not as good as R1s though.

My dealer put on slightly smaller diameter tires from a different model Branson on my machine. That lowers the CG some at the cost of lower ground clearance. It is still high enough and I'd be paying attention to what I drive over anyhow. Filled rear tires will also help lower the CG.

If you fill the holes yourself you may need to fill in the closest ones, then work outwards on the new less uneven ground.
 
   / Least Tippy Machine #17  
I see the big highway department tractors pulling their 15-foot bat wing cutters on slopes that make me dizzy.
They have very wide front axles, big weights on the front and the rear tires are also set very wide. I would think you could look into similar equipment for other tractor models.

If I can add a question to this topic.. since I have a dam that is hard to mow on the face near the water, straight up and down, forward and reversing until the clutch is burning hot... I'm pretty sure I could mow it sideways without risk of tipover... but here's the question:

Has anyone tried having a friend with a heavy truck drive along the level top of the dam with a chain to the ROPS to be sure it wouldn't try to tip over? Just wondering about trying it. It would save me at least an hour and lots of wear and tear.
Funny you mention that. Driving through western MO Tuesday, we saw several mowing crews. There was a large JD tractor with a large batwing mower that appeared to have tried to take the sideslope under an overpass. He apparently slipped sideways downhill and had become wedged against the bridge posts. He was standing there in front of it holding a chain.

Another guy in a similar tractor with similar mower was trying to climb the hill from the opposite side to, I guess, try and pull him up the hill off the pilings. However, that machine was sliding backwards down the hill.

My guess is they had to end up calling for assistance.

Crazy steep slopes. I wouldn't have worried to much about tipping, but sliding is another story.
 
   / Least Tippy Machine #18  
Op,

Is it just the dropping of a wheel into a hole you're concerned about, or are your slopes and hills steep?

There are apps you can get for your smart phone that will allow you to measure slopes and angles in the field. The one I use is called MultiClinometer (android). You can measure in percent of grade, or degree of slope.

Here is a slope chart for reference:

Slope Angle Chart.jpg


There are several things you can do to your tractor to make it less "tippy". But we should start with a reference of how much slope you're dealing with. Can you measure a couple of your "bad" spots?
 
Last edited:
   / Least Tippy Machine #20  
What is your objective? If you are wanting to fill the holes are you hauling in dirt? Is there dirt stockpiled on the land? Are you trying to use a box blade to fill in the holes? Details will get you better answers.
 

Tractor & Equipment Auctions

Adams 5 ton Fertilizer Buggy / Wagon (A51039)
Adams 5 ton...
2015 JEEP PATRIOT (A51406)
2015 JEEP PATRIOT...
2019 Caterpillar 815K Articulated Compactor (A49461)
2019 Caterpillar...
FIATALLIS MOTOGRADER (A50854)
FIATALLIS...
FORREST RIVER CHEROKEE CAMPER (A50854)
FORREST RIVER...
EZ-GO GOLF CART (A51243)
EZ-GO GOLF CART...
 
Top