Landscape Rake

[1m21]

Here is a landscape rake I made in a few hours. I had a back blade that came with the tractor so I figured I could to use that frame for both the blade and the rake. (the green parts are all I had to make)

 

[MJPetersen]

Very good job! It looks great and will work for you. Why did you not make provision for pushing the raked up leaves, roots, brush into a pile?

Mike

 

[3RRL]

That's a heck of job to get done in a few hours. Great going!

 

[GuglioLS]

Here is a landscape rake I made in a few hours......snip (the green parts are all I had to make)

A few hours! wow that's great, it sure came out nice looking, great job. What are some of the things you will be using it for? Where did you get the Tines?

Larry

 

[1m21]

That's a heck of job to get done in a few hours. Great going!

I cheated a little. The holes in the angle were punched and the top plate was laser cut.

 

[Renze]

I cheated a little. The holes in the angle were punched and the top plate was laser cut.

Where i work, that's not called cheating, but working smart

Just working hard, doesnt pay: Working smart to begin with, and then working reasonably hard, (but not to exhaustion, we need our employees the next day too) is the deciding factor in survival of the fittest companies.

 

[SkunkWerX]

Nice job.
It's always good to see folks get additional use out of existing pieces.

You may want to round over those right angles on the top ends of the angled-steel that holds the tines. Those points look like they could be snaggers.

I own several pairs of pants with rips that correspond to the height of the sharp edges on some of my implements.

.

 

[1m21]

Where did you get the Tines?

Agri Supply Company

2 HOLE LANDSCAPE RAKE TINE M/IN ITALY - Agri Supply