JX80

   / JX80 #1  

wadem

New member
Joined
May 11, 2015
Messages
3
Location
Mesick, MI
Tractor
IH966,Farmall F12, Case 430, CasiIH jx80
Where is the adjustment for how fast the 3 point goes down on 2008 CaseIH JX80?
I have moved draft control all over the place and still very very very slow to lower 3 point. Trying to use backblade on it.
 
   / JX80 #2  
There should be a valve on the floor or in the panel behind your feet that controls the drop rate of the 3 point.
 
   / JX80 #3  
I'm pretty sure there is a cable for the lift-o-matic switch on the hitch valve. Hitch valve is under remote valve on top pto. Can adjust the cable to speed drop rate.
 
   / JX80
  • Thread Starter
#4  
Thanks boudreaux81. I found that and adjusted it and you were spot on. Finally someone who actually knows.
 
   / JX80
  • Thread Starter
#6  
now for another problem. It seems to be in 4 wheel drive all the time. Lever moves but obviously won't disengage front drive
 
   / JX80 #8  
Yes as previous comment check see if shaft on side transmission is moving along with handle and not just the linkage. Could very well be broken roll pin. Sometimes you have to be slowly moving to disengage also.
 
   / JX80 #9  
Then also pinbolt Partno 5129031 that anchor the returnspring partno 5129033..........pinbolt broken off ? spring still there ?
 
Last edited:

Tractor & Equipment Auctions

Diamond C Trailers 26ft T/A Flatbed Tilt Trailer (A55787)
Diamond C Trailers...
2010 Ford Edge SE SUV (A51694)
2010 Ford Edge SE...
2010 Hyundai Elantra Touring Sedan (A54815)
2010 Hyundai...
2017 Ford Explorer AWD SUV (A53424)
2017 Ford Explorer...
2019 Dodge Journey Crossroad SUV (A53424)
2019 Dodge Journey...
2003 Atlas Copco 75kW ABB Rotterdam 220psi Air Compressor (A52377)
2003 Atlas Copco...
 
Top