Just another junk chainsaw

[xyz123]

New 501 metal with rubber coating 2 piece kit to replace the cheap plastic crap that comes on 4910 490.

 

[xyz123]

Well we both got our saws packed for shipping. So going to say the trade is a done deal.

 

[xyz123]

Dang the new 4910 isnt even here and a guy wants to trade me a new echo 2511PN for it.

Hmmm Dont really need a 4910 and rear handle version of 2511 to go along with clone 2511 be nice.

Plus side he already put a Egan pipe on it too.

 

[JeepHead]

Dang the new 4910 isnt even here and a guy wants to trade me a new echo 2511PN for it.

Hmmm Dont really need a 4910 and rear handle version of 2511 to go along with clone 2511 be nice.

Plus side he already put a Egan pipe on it too.


View attachment 2693293View attachment 2693294View attachment 2693295View attachment 2693292

I have a 2511T with the Egan pipe. It's an absolute screamer of a saw. I cut a lot of wood with that thing just because it's so dang fun. It would be a tough decision for me considering the 4910 and the 2511T are two of my most favorite saws.

 

[xyz123]

I have a 2511T with the Egan pipe. It's an absolute screamer of a saw. I cut a lot of wood with that thing just because it's so dang fun. It would be a tough decision for me considering the 4910 and the 2511T are two of my most favorite saws.

I have 2 501 muffler modded and a echo 490 ported already and a clone 2511 TH.

I am sort of leaning toward the rear handle 2511.

 

[JeepHead]

I have 2 501 muffler modded and a echo 490 ported already and a clone 2511 TH.

I am sort of leaning toward the rear handle 2511.

View attachment 2693299View attachment 2693300

I will like to see your comparison of the 2511 verses the clone.

two 501's? You lucky dog!

 

[xyz123]

I will like to see your comparison of the 2511 verses the clone.

two 501's? You lucky dog!

With that pipe on it is better then some guys port job and their muffler mod.

I did a thread on a bunch from dyno runs. That little pipe alone is most of the gains made.

Some using stock muffler but opened up and ported cylinders. Didnt gain as much as the pipe alone.

I have 1/4" mini micro chain on my clone for pruning cuts. The rear handle one has 325 80TXL nano narrow kerf

 

[JeepHead]

With that pipe on it is better then some guys port job and their muffler mod.

I did a thread on a bunch from dyno runs. That little pipe alone is most of the gains made.

Some using stock muffler but opened up and ported cylinders. Didnt gain as much as the pipe alone.

I have 1/4" mini micro chain on my clone for pruning cuts. The rear handle one has 325 80TXL nano narrow kerf

View attachment 2693309

I've been meaning to check the squish on my 2511T but haven't gotten around to it yet. May do that this weekend.

 

[xyz123]

Guy said he wants to trade. So when 4910 gets here. I am to get it out. Check over.
Test it stock and check tune where at stock.

Then muffler mod and retune and test. Then ship it off.

Amazing stuff.

 

[xyz123]

@JeepHead I ask some of the porters in my group. 2511 stock squish

About .032” or so. A gasket delete works on them but the cylinder extension bottoms out on some of them